Industrial — APPENDIX N — DIAGNOSTIC TOOL INFORMATION

WTEC III ELECTRONIC CONTROLS TROUBLESHOOTING MANUAL APPENDIX N — DIAGNOSTIC TOOL INFORMATION Support Information The ATDT™ is shipped with a paper Users Manual (GN3433EN), an extensive Help Menu (within the software) as well as a laminated tri-fold Job Aid card (JA3434EN). All of these sources will guide the user through most software installation questions as well as how the tool functions. Please refer to the hardware requirements listed above. Any attempt to run the application on a platform not meeting the defined requirements will result in less than satisfactory results.

If the problems you experience are related to the Windows ® operating system or to any problems with your PC please contact your company Information Technology department or refer to the documentation supplied with your PC. For problems relating specifically to the ATDT™ software, a Technical Support Help Desk phone number is provided with the ATDT™. Essential Tool Status The ATDT™ has been classified as an Essential tool for service outlets authorized as WT Maintenance and WT Overhaul locations. Those service outlets currently enrolled in the Essential tool program will receive an announcement letter regarding this tool.

Reprogramming Requirements The ATDT™ incorporates a reprogramming function which allows modification of certain transmission control system values. Activation of this reprogramming capability requires the user to complete an Allison ATDT™ Service Training program to insure safe utilization of this function. This training was also required for those who purchased the reprogramming PCMCIA card for the former diagnostic tool. Technicians who hold the appropriate training certificate for the PCMCIA can use the same certificate as authorization to activate the reprogramming function of the ATDT™.

Technicians not currently certified, who wish to activate the reprogramming function of the ATDT™, will be required to provide proof of completion of the ATDT™ Service Training Program (for course availability please contact your local Allison Transmission distributor training facility, or visit www.allisontransmission.com ). Purchasing Information The Allison Transmission Diagnostic Tool, available on CD only, can be purchased through SPX/ Kent Moore using part number: J-44950 Allison Transmission Diagnostic Tool* * Note: When shipped, the ATDT™ is a Diagnostic Only tool.

Users who wish to activate the embedded reprogramming function will be required to provide Kent-Moore with a copy of the approved training certificate, the serial number found on the CD, as well as the embedded key number found within the ATDT™. Kent-Moore will then provide a one-time use password, which will activate the reprogramming function. For purchase information please contact: SPX Corporation (Kent-Moore Service Solutions) 28635 Mound Road Warren, MI 48092 Phone 1-800-328-6657 www.toolsfortrucks.com Copyright © 2001 General Motors Corp.