Industrial — APPENDIX P — INPUT/OUTPUT FUNCTIONS

WTEC III ELECTRONIC CONTROLS TROUBLESHOOTING MANUAL D. SHIFT SELECTOR TRANSITION USES: When two shift selectors are used, to select which one is active. VARIABLES TO SPECIFY: None VOCATIONS: Various OPTIONAL CUSTOMER-FURNISHED VIW CONNECTOR(S) WIRE 155 SHIFT SELECTOR TRANSITION DASH SWITCH Open: Selector 1 Closed: Selector 2 When ECU is turned on, active shift selector is determined by current switch position. V-11 WIRE 161 SIGNAL RETURN V V-31 SELECTOR 1 SELECTOR 2 ECU SELECT SELECT Display of the inactive selector is disabled. R MODE R MODE To switch between selector 1 and selector 2, transmission must be in neutral and output speed below 60 rpm.

S N D N D For Shift Selector wiring requirements, see installation drawing AS07-27 (see SA2978 WTEC III Controls and General Information) V04860 Figure P–6. Shift Selector Transition Copyright © 2001 General Motors Corp. APPENDIX P — INPUT/OUTPUT FUNCTIONS WARNING! These schematics show the intended use of the specified controls features which have been validated in the configuration shown. Any miswiring or use of these features which differs from that shown could result in damage to equipment or property, personal injury, or loss of life. ALLISON TRANSMISSION IS NOT LIABLE FOR THE CONSEQUENCES ASSOCIATED WITH MISWIRING OR UNINTENDED USE OF THESE FEATURES. WARNING!

If this function is enabled in the shift calibration, the function MUST be integrated into the vehicle wiring. If the function is available in the shift calibration but will not be used in the vehicle, it MUST be disabled in the calibration.