WTEC III ELECTRONIC CONTROLS TROUBLESHOOTING MANUAL H. ENGINE BRAKE ENABLE AND PRESELECT REQUEST PLUS ENGINE BRAKE ENABLE OUTPUT WITH MULTI-LEVEL COMPESSION BRAKES USES: Used with multiple-level compression brakes to signal the ECU that the brake is active and to provide increased braking by preselecting a lower range. Also prevents engagement of engine brake with throttle > 0 or lockup OFF. VARIABLES TO SPECIFY: Preselect range. Standard value is fourth range. VOCATIONS:
Various LO/MED/HI SWITCH INFORMATION WIRE 119 On WIRE 169 Relay shown de-energized * ENGINE BRAKE LOW MED HIGH On On On E2 D2 ECM V V-3 WIRE 132 ENGINE BRAKE ENABLE OUPUT B1 Med/High Low/High SWITCHED POWER OPTIONAL CUSTOMER-FURNISHED VIW CONNECTOR(S) WIRE 143H SIGNAL RETURN VIM ECU Low/Med/High On/Off ENGINE SIGNAL GROUND S-32 WIRE 169 ENGINE BRAKE AND PRESELECT REQUEST NOTE: For multiple level engine brakes that communicate Engine Brake % Torque on J-1939, use the control interface for Engine Brake Enable and Preselect Request Plus Engine Brake Enable Output with Single Level Compression Brakes. S S-26 S-11 WIRE 119 ENGINE BRAKE AND PRESELECT REQUEST ENGINE CONTROL MODULE * NOTE:
The engine brake must provide a low engine speed shutoff feature, set to disable the brake at a speed slightly higher than idle rpm. Switch shown in “HIGH” position V04866.03 Figure P–13. Engine Brake Enable and Preselect Request Plus Engine Brake Enable Output With Multi-Level Compression Brakes Copyright © 2001 General Motors Corp. P–13 APPENDIX P — INPUT/OUTPUT FUNCTIONS WARNING! These schematics show the intended use of the specified controls features which have been validated in the configuration shown. Any miswiring or use of these features which differs from that shown could result in damage to equipment or property, personal injury, or loss of life.
ALLISON TRANSMISSION IS NOT LIABLE FOR THE CONSEQUENCES ASSOCIATED WITH MISWIRING OR UNINTENDED USE OF THESE FEATURES. NC COM NO