Industrial — APPENDIX P — INPUT/OUTPUT FUNCTIONS

WTEC III ELECTRONIC CONTROLS TROUBLESHOOTING MANUAL Y. ANTI-LOCK BRAKE RESPONSE WITH BRAKE PRESSURE SWITCH USES: Provides for enhanced control of lockup and retarder during hard braking conditions. Can be used separately or in conjunction with ABS. VARIABLES TO SPECIFY: None VOCATIONS:

Various OPTIONAL CUSTOMER-FURNISHED VIW CONNECTOR(S) BRAKE PRESSURE SWITCH ABS INPUT ( Р) NO ABS ABS INPUT (+) WIRE 161 SIGNAL RETURN WIRE 161 WIRE 161 * BRAKE PRESSURE SWITCH * V V-31 BRAKE PRESSURE SWITCH * Р OR Р Р OR Р V-27 WIRE 154 ABS RESPONSE SWITCHED POWER WIRE 154 WIRE 154 ECU ** ** Customer-furnished relay shown de-energized Customer-furnished relay shown de-energized S This configuration is to be used if the ABS system provides a power (–) signal when active. This configuration is to be used if the ABS system provides a power (+) signal when active. ** * NOTE: Brake Pressure Switch is closed when brakes are applied.

Switch pressure setting to be established by customer evaluation (typically 30–35 psi). Anti-Lock Brake Controls V04878.01 Figure P–27. Anti-Lock Brake Response With Brake Pressure Switch P–28 Copyright © 2001 General Motors Corp. APPENDIX P — INPUT/OUTPUT FUNCTIONS WARNING! These schematics show the intended use of the specified controls features which have been validated in the configuration shown. Any miswiring or use of these features which differs from that shown could result in damage to equipment or property, personal injury, or loss of life. ALLISON TRANSMISSION IS NOT LIABLE FOR THE CONSEQUENCES ASSOCIATED WITH MISWIRING OR UNINTENDED USE OF THESE FEATURES. NC COM NO NC COM NO