Industrial — APPENDIX P — INPUT/OUTPUT FUNCTIONS

WTEC III ELECTRONIC CONTROLS TROUBLESHOOTING MANUAL Z. RETARDER ENABLE USES: Provides for operator ON/OFF control of the retarder, transmission temperature indication, and brake lights during retarder operation. USES: None VOCATIONS: Various. This function is required for retarder-equipped transmissions. OPTIONAL CUSTOMER-FURNISHED VIW CONNECTOR(S) ** SWITCHED POWER UNSWITCHED POWER WIRE 105 RETARDER OR SUMP TEMP NOTE: Use of this light is optional with a transit bus or when using a transmission temp gauge.

** CUSTOMER- FURNISHED RELAY BRAKE LIGHTS SWITCH V-19 BRAKE PEDAL SWITCH TRANS TEMP (YELLOW) * NC V V-29 V-31 WIRE 137 SERVICE BRAKE STATUS If current in lamp circuit exceeds 0.5 amp, ground lamp through a relay COM NO + CRUISE CONTROL “BRAKE STATUS” INPUT V-18 NOTE: If vehicle is equipped with air brakes, this switch should close at 2–5 psi. Closed = Brakes On RETARDER ON ECU WIRE 161 SIGNAL RETURN SWITCHED POWER S-32 S-27 NC S RETARDER DASH SWITCH E1 COM NO BRAKE LIGHTS WIRE 163 RETARDER ENABLE WIRE 125 RETARDER INDICATOR WIRE 143H SIGNAL RETURN Closed = On WIRE 105 C2 ** VIM ** Relays shown de-energized SWITCHED POWER V07170 Figure P–28.

Retarder Enable Copyright © 2001 General Motors Corp. P–29 APPENDIX P — INPUT/OUTPUT FUNCTIONS WARNING! These schematics show the intended use of the specified controls features which have been validated in the configuration shown. Any miswiring or use of these features which differs from that shown could result in damage to equipment or property, personal injury, or loss of life. ALLISON TRANSMISSION IS NOT LIABLE FOR THE CONSEQUENCES ASSOCIATED WITH MISWIRING OR UNINTENDED USE OF THESE FEATURES. NC COM NO D1