Industrial — APPENDIX P — INPUT/OUTPUT FUNCTIONS

WTEC III ELECTRONIC CONTROLS TROUBLESHOOTING MANUAL AK. AUTOMATIC NEUTRAL — DUAL INPUT WITH SERVICE BRAKE STATUS — AUTOMATED SIDE LOADER ACTIVATED USES: Provides for automatic selection of NEUTRAL and activation of fast idle when loading arm is activated. Automatically re-engages transmission when loading arm is retracted if service brake is depressed. Only re-engagement of forward is allowed. Reverse is not re-engaged. VARIABLES TO SPECIFY: Max output rpm to enable Neutral, max engine rpm for PTO engagement, max engine rpm for PTO operation, max output rpm for PTO engagement, max output rpm for PTO operation. VOCATIONS:

Refuse packer, recycling truck OPTIONAL CUSTOMER-FURNISHED VIW CONNECTOR(S) SWITCHED POWER Relays shown de-energized PTO SWITCH PTO PRESSURE SWITCH WIRE 118 PTO ENABLE INPUT BRAKE PEDAL SWITCH WIRE 137 SERVICE BRAKE STATUS WIRE 161 SIGNAL RETURN WIRE 117 PACK ENABLE Closed = Brakes On DASH LIGHT Switch opens when rail is fully retracted A2 ECU V-2 AUTO NEUTRAL DASH SWITCH F3 PTO WIRE 153 AUTO NEUTRAL PACKER INPUT FAST IDLE SOLENOID S NOTE: The fast idle solenoid must be diode suppressed. WIRE 112 PTO ENABLE OUTPUT Switch opens when arm is fully down NOTE: Transmission shifts to Neutral when either rail switch or arm switch is closed (if other conditions are satisfied).

Transmission shifts back to Drive if both switches open, service brake switch is closed, and engine speed drops below 900 rpm within 2.5 seconds of both switches closing. WIRE 114 NEUTRAL INDICATOR FOR PTO NOTE*: Typical engine "Fast Idle" control system. Actual configuration may vary from that shown. Consult the engine manufacturer. V07128 Figure P–37. Automatic Neutral — Dual Input With Service Brake Status — Automated Side Loader Activated P–38 Copyright © 2001 General Motors Corp. APPENDIX P — INPUT/OUTPUT FUNCTIONS WARNING! These schematics show the intended use of the specified controls features which have been validated in the configuration shown.

Any miswiring or use of these features which differs from that shown could result in damage to equipment or property, personal injury, or loss of life. ALLISON TRANSMISSION IS NOT LIABLE FOR THE CONSEQUENCES ASSOCIATED WITH MISWIRING OR UNINTENDED USE OF THESE FEATURES. WARNING! This feature is meant to be used in applications where the vehicle operator remains in the cab. If the operator leaves the vehicle, the park brake must be engaged and Neutral must be selected prior to the operator exiting the cab. In addition, vehicles using this feature must have the following Warning sticker visible in the vehicle cab: “WARNING:

Set Park Brake and select Neutral before exiting cab!” V V-13 V-31 V-30 NC COM NO NC COM NO F3 SEE NOTE * A3 VIM