Industrial — APPENDIX P — INPUT/OUTPUT FUNCTIONS

WTEC III ELECTRONIC CONTROLS TROUBLESHOOTING MANUAL AK. AUTOMATIC NEUTRAL — DUAL INPUT WITH SERVICE BRAKE STATUS — DASH SWITCH ACTIVATED USES: Provides for selection of NEUTRAL and enabling fast idle through activation of a dash mounted switch. Automatically re-engages transmission when switch is opened if service brake is depressed. Only re-engagement of forward is allowed. Reverse is not re-engaged. VARIABLES TO SPECIFY: Max output rpm to enable Neutral, max engine rpm for PTO engagement, max engine rpm for PTO operation, max output rpm for PTO engagement, max output rpm for PTO operation. VOCATIONS:

Refuse packer, recycling truck OPTIONAL CUSTOMER-FURNISHED VIW CONNECTOR(S) SWITCHED POWER Relays shown de-energized PTO SWITCH PTO PRESSURE SWITCH WIRE 118 PTO ENABLE INPUT BRAKE PEDAL SWITCH WIRE 137 SERVICE BRAKE STATUS Closed = Brakes On WIRE 161 SIGNAL RETURN WIRE 117 PACK ENABLE DASH LIGHT AUTO NEUTRAL DASH SWITCH A2 PTO ECU V-2 WIRE 153 AUTO NEUTRAL PACKER INPUT F3 FAST IDLE SOLENOID S WIRE 112 PTO ENABLE OUTPUT + NOTE: The fast idle solenoid must be diode suppressed. NOTE: Transmission shifts to Neutral when dash switch is closed (if other conditions are satisfied).

Transmission shifts back to Drive when switch is opened, service brake switch is closed, and engine speed drops below 900 rpm within 2.5 sec. Otherwise, transmission stays in Neutral. WIRE 114 NEUTRAL INDICATOR FOR PTO NOTE*: Typical engine "Fast Idle" control system. Actual configuration may vary from that shown. Consult the engine manufacturer. V07129 Figure P–38. Automatic Neutral — Dual Input With Service Brake Status — Dash Switch Activated Copyright © 2001 General Motors Corp. P–39 APPENDIX P — INPUT/OUTPUT FUNCTIONS WARNING! WARNING! These schematics show the intended use of the specified controls features which have been validated in the configuration shown.

Any miswiring or use of these features which ddiiffffeerrss ffrroomm t thhaatt s hshoowwnn c ocouuldld c arues ue lut ninin dteanmdaegde s etole ecqtiuoinp omf ernatn ogre po r ooptheretry u, npper seodnicatla ibnljeu orpy,e roart il onss r oesf ullitfien. gA iLnL dIaSmOaNg eT tRo AeqNuSipMmISenStI OorN p rISop NerOtyT, LpeIrAsBonLaEl iFnOjuRry ,T oHrE lo CssO oNf SliEfeQ. AULELNICSEOSN A TSRSAONCSIAMTIESSDI OWNI TISH NMOITS WLIIARBINLGE OFORR U NTIHNTEE NCDOENDS EUQSEU EONFC TEHSE SAES SFOEACTIAUTREEDS . WITH MISWIRING OR UNINTENDED USE OF THESE FEATURES. WARNING! This feature is meant to be used in applications where the vehicle operator remains in the cab.

If the operator leaves the vehicle, the park brake must be engaged and Neutral must be selected prior to the operator exiting the cab. In addition, vehicles using this feature must have the following Warning sticker visible in the vehicle cab: “WARNING: Set Park Brake and select Neutral before exiting cab!” V V-13 V-31 V-30 NC COM NO NC COM NO F3 SEE NOTE * A3 VIM