WTEC III ELECTRONIC CONTROLS TROUBLESHOOTING MANUAL AK. AUTOMATIC NEUTRAL — DUAL INPUT WITH SERVICE BRAKE STATUS — WORK BRAKE ACTIVATED USES: Provides for automatic selection of NEUTRAL and activation of PTO when work brake is applied. Automatically re-engages transmission when work brake is released (if service brake is depressed). Only re-engagement of forward is permitted. Reverse is not re-engaged. VARIABLES TO SPECIFY: Max output rpm to enable Neutral, max engine rpm for PTO engagement, max engine rpm for PTO operation, max output rpm for PTO engagement, max output rpm for PTO operation. VOCATIONS:
Refuse packer, recycling truck WIRE 137 SERVICE BRAKE STATUS BRAKE PEDAL SWITCH Relays shown de-energized SEE NOTE* SWITCHED POWER PTO PRESSURE SWITCH WIRE 118 PTO ENABLE INPUT WIRE 161 SIGNAL RETURN V WIRE 117 PACK ENABLE DASH LIGHT ECU V-2 “AUTO NEUTRAL” CAB SWITCH PTO OPTIONAL CUSTOMER- FURNISHED VIW CONNECTOR(S) WIRE 153 AUTO NEUTRAL PACKER INPUT S speed drops to 900 rpm within 2.5 sec. Other- wise transmission stays in Neutral. CUSTOMER SUPPLIED RELAY + Р WIRE 112 PTO ENABLE OUTPUT WIRE 114 NEUTRAL INDICATOR FOR PTO SWITCHED POWER NOTE*: Typical engine "Fast Idle" control system. Actual configuration may vary from that shown. Consult the engine manufacturer. V07131 Figure P–40.
Automatic Neutral — Dual Input With Service Brake Status — Work Brake Activated Copyright © 2001 General Motors Corp. P–41 APPENDIX P — INPUT/OUTPUT FUNCTIONS WARNING! These schematics show the intended use of the specified controls features which have been validated in the configuration shown. Any miswiring or use of these features which differs from that shown could result in damage to equipment or property, personal injury, or loss of life. ALLISON TRANSMISSION IS NOT LIABLE FOR THE CONSEQUENCES ASSOCIATED WITH MISWIRING OR UNINTENDED USE OF THESE FEATURES. V-29 V-13 V-31 V-30 NC COM NO A2 NC F3 COM NO VIM SWITCHED POWER NOTE: The fast idle solenoid NC COM WORK BRAKE NC NC COM NC COM NO