WTEC III ELECTRONIC CONTROLS TROUBLESHOOTING MANUAL AL. SHIFT SELECTOR TRANSITION AND SECONDARY SHIFT SCHEDULE WITH AUTO NEUTRAL USES: Provides for operator selection of dual shift selectors and shift schedules. Primary mode will always be active when shift selector 1 is selected, and secondary mode will always be active when shift selector 2 is selected. VARIABLES TO SPECIFY: None VOCATIONS: Dual-station refuse vehicles Figure P–43. Shift Selector Transition and Secondary Shift Schedule With Auto Neutral P–44 Copyright © 2001 General Motors Corp. APPENDIX P — INPUT/OUTPUT FUNCTIONS WARNING!
These schematics show the intended use of the specified controls features which have been validated in the configuration shown. Any miswiring or use of these features which differs from that shown could result in damage to equipment or property, personal injury, or loss of life. ALLISON TRANSMISSION IS NOT LIABLE FOR THE CONSEQUENCES ASSOCIATED WITH MISWIRING OR UNINTENDED USE OF THESE FEATURES. WARNING! If this function is enabled in the shift calibration, the function MUST be integrated into the vehicle wiring. If the function is available in the shift calibration but will not be used in the vehicle, it MUST be disabled in the calibration.
OPTIONAL CUSTOMER-FURNISHED WIRE 155 DASH SWITCH VIW CONNECTOR(S) Open: Selector 1 and primary mode shift schedule SHIFT SELECTOR TRANSITION AND Closed: Selector 2 and secondary mode shift schedule SECONDARY SHIFT SCHEDULE V-31 When ECU is turned on, active shift selector is WIRE 161 V V-11 determined by current SIGNAL RETURN LEFT switch position.
V-29 WIRE 137 BRAKE SELECTOR SELECTOR SERVICE 1 2 ECU S B TR AA TK UE S NC RIGHT SELECT SELECT D seis lep cla toy r o isf t dh ie s ain ba lec dti .ve BRAKE S-18 COM NO To switch between WIRE 166 SWITCHED R MODE R MODE selector 1 and selector 2, SECONDARY MODE POWER N N Neutral must be selected and attained, and output S INDICATOR CUSTOMER-SUPPLIED D D speed must be below RELAY SHOWN 60 rpm. DE-ENERGIZED For Shift Selector wiring requirements, see installation drawing AS07-27 (see SA2978 WTEC III Controls and General Information) V07132 OPTIONAL CUSTOMER-FURNISHED WIRE 155 DASH SWITCH VIW CONNECTOR(S) Open: Selector 1 and primary mode shift schedule SHIFT SELECTOR TRANSITION AND Closed:
Selector 2 and secondary mode shift schedule SECONDARY SHIFT SCHEDULE V-31 When ECU is turned on, active shift selector is WIRE 161 V V-11 determined by current SIGNAL RETURN LEFT switch position. V-29 WIRE 137 BRAKE SELECTOR SELECTOR SERVICE 1 2 ECU S B TR AA TK UE S NC RIGHT SELECT SELECT D seis lep cla toy r o isf t dh ie s ain ba lec dti .ve BRAKE S-18 COM NO To switch between WIRE 166 SWITCHED R MODE R MODE selector 1 and selector 2, SECONDARY MODE POWER N N Neutral must be selected and attained, and output S INDICATOR CUSTOMER-SUPPLIED D D speed must be below RELAY SHOWN 60 rpm.
DE-ENERGIZED For Shift Selector wiring requirements, see installation drawing AS07-27 (see SA2978 WTEC III Controls and General Information) V07132 S S-18