WTEC III ELECTRONIC CONTROLS TROUBLESHOOTING MANUAL C. RANGE INDICATOR USES: Used with auxiliary vehicle systems to permit operation only in specified transmission range(s). VARIABLES TO SPECIFY: Range or ranges to be indicated VOCATIONS: Various SWITCHED POWER NOTE: If the auxiliary vehicle system is an inductive load, it must be diode suppressed. V V-2 WIRE 114 RANGE INDICATOR Contacts close when transmission is in specified range or ranges. OPTIONAL CUSTOMER-FURNISHED VIW CONNECTOR(S) NC ECU A2 COM NO A3 F3 SWITCHED POWER S Relay shown de-energized VIM NOTE: This signal should not be used to automatically apply park brake or service brakes when transmission is shifted to Neutral.
V07172 Figure P–49. Range Indicator P–52 Copyright © 2001 General Motors Corp. APPENDIX P — INPUT/OUTPUT FUNCTIONS WARNING! These schematics show the intended use of the specified controls features which have been validated in the configuration shown. Any miswiring or use of these features which differs from that shown could result in damage to equipment or property, personal injury, or loss of life. ALLISON TRANSMISSION IS NOT LIABLE FOR THE CONSEQUENCES ASSOCIATED WITH MISWIRING OR UNINTENDED USE OF THESE FEATURES. AUXIL VEHI SYS IARY CLE TEM