Industrial — APPENDIX P — INPUT/OUTPUT FUNCTIONS

WTEC III ELECTRONIC CONTROLS TROUBLESHOOTING MANUAL E. OUTPUT SPEED INDICATOR — B USES: To signal that the transmission output shaft has exceeded a specified value. VARIABLES TO SPECIFY: Rpm to turn output ON and to turn output OFF. The ON value must be higher than the OFF value. VOCATIONS: Various SWITCHED POWER CUSTOMER- FURNISHED RELAY NC V COM NO OUTPUT SPEED INDICATOR – B OPTIONAL CUSTOMER-FURNISHED VIW CONNECTOR(S) Relay shown de-energized ECU S NOTE: The ON and OFF control values for this function may be specified within the same range of values which are permitted for “Output Speed Indicator – A”.

However, the control values for this function may not be adjusted using the Pro-Link ® Diagnostic Tool. Therefore, if adjustment of these values is a desirable feature, the “Output Speed Indicator – A” function must be used. V04895 Figure P–51. Output Speed Indicator — B P–54 Copyright © 2001 General Motors Corp. APPENDIX P — INPUT/OUTPUT FUNCTIONS WARNING! These schematics show the intended use of the specified controls features which have been validated in the configuration shown. Any miswiring or use of these features which differs from that shown could result in damage to equipment or property, personal injury, or loss of life.

ALLISON TRANSMISSION IS NOT LIABLE FOR THE CONSEQUENCES ASSOCIATED WITH MISWIRING OR UNINTENDED USE OF THESE FEATURES. TRANSM OR VE OVERS INDIC ISSION HICLE PEED ATOR