WTEC III ELECTRONIC CONTROLS TROUBLESHOOTING MANUAL F. PTO OVERSPEED INDICATOR USES: Turn on dash light when PTO reaches an overspeed condition. VARIABLES TO SPECIFY: Rpm to turn ON; rpm to turn OFF. VOCATIONS: Various SWITCHED POWER OPTIONAL CUSTOMER-FURNISHED VIW CONNECTOR(S) V PTO OVERSPEED INDICATOR PTO OVERSPEED ECU If current in lamp circuit exceeds 0.5 amp, ground lamp through a relay. NC S Output switches from open to ground when PTO speed (engine speed) exceeds a calibration value. PTO OVERSPEED COM NO Output switches from ground to open when engine speed falls below a lower calibration value. PTO OVERSPEED INDICATOR SWITCHED POWER V04896.01 Figure P–52.
PTO Overspeed Indicator Copyright © 2001 General Motors Corp. P–55 APPENDIX P — INPUT/OUTPUT FUNCTIONS WARNING! These schematics show the intended use of the specified controls features which have been validated in the configuration shown. Any miswiring or use of these features which differs from that shown could result in damage to equipment or property, personal injury, or loss of life. ALLISON TRANSMISSION IS NOT LIABLE FOR THE CONSEQUENCES ASSOCIATED WITH MISWIRING OR UNINTENDED USE OF THESE FEATURES.