WTEC III ELECTRONIC CONTROLS TROUBLESHOOTING MANUAL S. NEUTRAL INDICATOR FOR PTO AND PTO ENABLE — NEUTRAL OPERATION ONLY USES: Provides for fast idle operation in neutral, and PTO engagement with overspeed protection. VARIABLES TO SPECIFY: Max engine rpm for PTO engagement, max engine rpm for PTO operation, max output rpm for PTO engagement, max output rpm for PTO operation. VOCATIONS: Refuse packer, recycling truck. SYSTEM OPERATION: Operator selects NEUTRAL to enable fast idle. Transmission shifts to neutral if throttle and output speed are low.
When DRIVE is re-selected, fast idle is interrupted and transmission shifts to drive if engine speed drops below 900 rpm within approximately two seconds. SWITCHED POWER WIRE 118 PTO ENABLE INPUT PTO SWITCH PTO PRESSURE SWITCH WIRE 112 PTO ENABLE OUTPUT FAST IDLE CONTROL WIRE 114 NEUTRAL INDICATOR FOR PTO ECU OPTIONAL CUSTOMER-FURNISHED VIW CONNECTOR(S) * FAST IDLE SOLENOID S POWER NOTE: The fast idle solenoid must be diode-suppressed. Relays shown de-energized SEE NOTE * NOTE*: Typical engine "Fast Idle" control system. Actual configuration may vary from that shown. Consult the engine manufacturer. V07134 Figure P–58.
Neutral Indicator for PTO and PTO Enable — Neutral Operation Only P–66 Copyright © 2001 General Motors Corp. APPENDIX P — INPUT/OUTPUT FUNCTIONS WARNING! These schematics show the intended use of the specified controls features which have been validated in the configuration shown. Any miswiring or use of these features which differs from that shown could result in damage to equipment or property, personal injury, or loss of life. ALLISON TRANSMISSION IS NOT LIABLE FOR THE CONSEQUENCES ASSOCIATED WITH MISWIRING OR UNINTENDED USE OF THESE FEATURES. V V-22 V-2 PTO VIM NC COM NO GROUND NC NC COM NO COM A3 D2 A2 D2 NC COM NO