WTEC III ELECTRONIC CONTROLS TROUBLESHOOTING MANUAL CODE 13 XX — ECU INPUT VOLTAGE (Figure 6–2) DIAGNOSTIC CODES Main code 13 indicates either a high or low input voltage. Low voltage is less than 8 volts. High voltage is over 33 volts. Common causes for a low voltage code are: Bad batteries Faulty vehicle charging system No dedicated power and ground connection directly to the battery or through an electronic bus bar to the battery Common causes for the high voltage code are: Faulty vehicle alternator Faulty vehicle voltage regulator In the event of a power loss, the transmission fails to the ranges indicated in the following, depending upon which latch valve releases first: A.
Active Indicator Clearing Procedure: Power down Manual Self-clearing B. Troubleshooting: 1. Connect the diagnostic tool and turn on vehicle ignition. Select Diagnostic Data to find input voltage. Record reading. 2. Turn off vehicle ignition and remove the connectors from the ECU. 3. Check system voltage at wire 136A and 136C, pin V1 and V16. If power is low or high at this point, and the diagnostic tool reading is also low or high, the vehicle wiring is suspect. Check for fuse problems, lack of battery-direct power and ground, faulty charging system/batteries, and loose or dirty connections (see Appendix A).
Power may also be low or high at pins V1 and V16 (system power) if the batteries/charging system is faulty. Bad grounds may also cause incorrect in- put power readings. Copyright © 2001 General Motors Corp. 6–21 Attained Range Fail to Range Reverse and neutral Neutral Low, 1 3C 2, 3, 4 4C usually, 3C sometimes 5 4C usually, 5C sometimes 6 5C Main Code Subcode Meaning 13 12 Battery voltage to the ECU too low 13 13 Battery voltage to the ECU too low (medium) 13 23 Battery voltage to the ECU too high