WTEC III ELECTRONIC CONTROLS TROUBLESHOOTING MANUAL CODE 14 XX — OIL LEVEL SENSOR (OLS) (Figure 6–3) DIAGNOSTIC CODES Copyright © 2001 General Motors Corp. 6–25 The oil level sensor (OLS) must have been recognized by autodetect or manually selected using the ATDTTM or Pro-Link® (see User Guide GN3433EN or WTEC III Pro-Link® Manual) before these codes can be logged. See Paragraphs 1–9 and 1–10 for further information. Code 14 12 indicates the ECU has detected a voltage signal in the low error zone. Code 14 12 can be caused by: • Faulty wiring to the OLS • A faulty OLS • A faulty ECU CAUTION: Never use a volt/ohmmeter to measure any parameters on the OLS. Damage to the OLS will result.
OLS ground wire 135B is common to the TPS and the RMR devices. A power wire short-to-ground for any of these devices will cause “sensor failed low” codes (21 12 and 64 12) and shutdown of the electronic pushbutton or lever selector. An OLS signal open or short-to-ground results in a code 14 12 only. Code 14 23 should not occur in most instances. However, this code may be set if wire 165 (OLS Signal) is shorted to a wire carrying greater than 5.0V which is the maximum voltage signal from the oil level sensor. A permanent maximum voltage signal generates a steady OLS sensor maximum count and a maximum fluid level overfill indication.
A maximum overfill indication occurs if signal wire 165 or power wire 124 is shorted to battery or the ground wire (wire 135) is open between the OLS and the sump temperature sensor branch. An open in the ground circuit wire 135 in the portion common to the OLS, TPS and RMR devices results in code 14 12, 21 23, and 64 23. If the ECU software supports it, Oil Level Sensor counts can be read by the ATDTTM or a DDR with Pro-Link® version 3.0 (or later). For a complete description of fluid level checking procedures using the oil level sensor, see Section 5. Normal operation of the OLS can be checked as follows: Attach the DDR and display OIL LEVEL COUNTS.
Read the number of counts when the engine is not running, but the ignition is ON. The count reading should be near 255. Start the engine and observe the counts. In normal operation, the count should be 100–200 because the oil level drops when the engine starts and oil from the sump is delivered to other parts of the transmission. NOTE: Intermittent connections or lack of battery-direct power and ground connections can cause this and other electronic control codes. Main Code Subcode Meaning 14 12 Oil level sensor failed low 14 23 Oil level sensor failed high (not used) A. Active Indicator Clearing Procedure:
• Power down • Manual • Self-clearing Main Code Subcode Meaning 14 12 Oil level sensor failed low 14 23 Oil level sensor failed high (not used)