WTEC III ELECTRONIC CONTROLS TROUBLESHOOTING MANUAL CODE 14 XX — OIL LEVEL SENSOR (OLS) (Figure 6–3) DIAGNOSTIC CODES 6–26 Copyright © 2001 General Motors Corp. NOTE: Before troubleshooting, read Paragraph 6–6. Also, check the following: • Fluid level, using dipstick • Battery voltage • ECU input voltage • Other diagnostic codes B. Troubleshooting: The following procedure is to find the cause for an OLS problem. The procedure is sequential. Follow the procedure until the cause for the OLS problem is found and repaired. Once the problem is found and repaired, STOP. For example, if the problem is fixed in Step 3, there is no need to continue to the other steps. 1.
Disconnect the external wiring harness at the transmission feedthrough connector. With the igni- tion ON, verify there is 5.0 VDC between the OLS power and ground pins (see page D–10) on the external harness connector. This is to verify that power and ground are getting to the OLS. If the 5.0 VDC is not present, check the wiring for the OLS power and ground circuits (wires 124–T9 and 135–T25, respectively). If there are no wiring problems (opens, shorts-to-ground, shorts-to- battery), and if the 5.0 VDC is present, go to Step 2. 2. Observe the OIL LEVEL COUNTS on the DDR while jumpering the OLS power pin to the OLS signal pin.
If the count jumps from 0 to 250+, the OLS signal line is good and the ECU function is good. Continue to Step 3. If the count remains at zero, locate and repair problems in the wiring of OLS signal (wire 165–T26). If there are no wiring problems, and the count still remains at zero, the ECU may be bad. Go to Step 5. 3. If all checks prior to this have been normal, the problem is either in the OLS itself, the internal harness wires or the transmission side of the feedthrough harness connection. Inspect the transmission feedthrough harness connector to be sure that the OLS power, ground and signal pins are not loose or out of position. Correct any connector problems found.
Reconnect the external harness to the transmission feedthrough harness connector. See if Code 14 12 recurs before continuing to Step 4. 4. Consult the appropriate transmission Service Manual for proper procedure and remove the control module from the transmission. Remove the OLS from the channel plate. Reconnect the external harness to the transmission feedthrough connector, if not done in Step 3. With the ignition ON, observe OIL LEVEL COUNTS on the DDR. With the OLS in normal position, the count should be 8–35. Invert the OLS and the count should be 192–255. If the counts are abnormal, replace the sensor. Check the new sensor in both normal and inverted positions.
If the counts respond correctly, the problem should be resolved. Attach the new OLS to the channel plate and reinstall the control module using the appropriate transmission Service Manual for proper procedure. CAUTION: Using an unmatched ECU/CIN combination may result in additional codes being set or in transmission clutch damage. Using an ECU from another vehicle is not a recommended procedure where the test will involve driving the vehicle. This is because the stored adaptive information is tuned to the original vehicle's transmission and those adaptive settings may not perform as expected in another vehicle. Transmission performance could be worse and damage to the clutches may occur.