Industrial — CODE 33 XX — SUMP OIL TEMPERATURE SENSOR

WTEC III ELECTRONIC CONTROLS TROUBLESHOOTING MANUAL CODE 33 XX — SUMP OIL TEMPERATURE SENSOR (Figure 6–11) NOTE: When an ECU with a version 8 calibration(CIN=0A...) is used with a Trans ID 2 transmission, 33 XX codes are set because the ECU does not have the proper calibrations for the TID 2 thermistors. The ECU calibration must be updated to version 8A (CIN=0B...). TransID (TID) information related to thermistor changes is in Paragraph 1–11 and detailed troubleshooting information for TID 2 thermistors is shown in Appendix Q. Main code 33 indicates the sump temperature sensor is providing a signal outside the usable range of the ECU.

This code indicates the sensor failed showing abnormally high or low temperature readings. Main code 33 can be caused by a component or circuit failure or by extremely high or low temperatures. There are no operational inhibits related to main code 33. The ECU assumes a hardware failure and that transmission temperatures are normal (93єC; 200єF). Temperatures above or below normal cause poor shift quality. NOTE: Code 33 23 in conjunction with code 21 23 indicates the loss of common ground (wire 135) between the throttle and temperature sensors. A. Active Indicator Clearing Procedure: Power down Manual Self-clearing NOTE: Before troubleshooting, read Paragraph 6–6.

Also, check the transmission fluid level. B. Troubleshooting: NOTE: Code 33 12 can be caused when the +5V power line (wire 124) is shorted to ground or open. Wire 124 also provides power for the OLS, TPS, RMR, retarder temperature sensor, and shift selectors and is present in all three ECU connectors. 1. If possible, check the sump temperature with a DDR. Use the fastest sample rate available on the DDR . This is necessary to catch momentary changes due to an intermittent open or short to ground. If a DDR is not available, use the shift selector display to determine if the code is active (refer to Paragraph 6–2).

Disconnect the transmission “T” harness at the ECU and check resistance of the sensor and compare with Figure 6–12 for TID 1 and Appendix Q for TID 2. 2. If Step (1) reveals that the extreme temperature indication is no longer present, the temperature limit could have been reached due to operational or ambient temperature extremes. Also, you may be experiencing an intermittent problem and the code will not be active. Proceed cautiously, it is unlikely there is a sensor hardware fault. 3. Disconnect the external harness at the transmission. Check the connectors and terminals for dirt, corrosion, or damage. Clean or replace as necessary. Copyright © 2001 General Motors Corp.

6–53 Main Code Subcode Meaning 33 12 Sump oil temperature sensor failed low 33 23 Sump oil temperature sensor failed high