Industrial — CODE 33 XX — SUMP OIL TEMPERATURE SENSOR

WTEC III ELECTRONIC CONTROLS TROUBLESHOOTING MANUAL CODE 33 XX — SUMP OIL TEMPERATURE SENSOR (Figure 6–11) 6–54 Copyright © 2001 General Motors Corp. TEMPERATURE SENSOR CHART TEMPERATURE VS.

RESISTANCE TEMP °C TEMP °F OHMS 2900 -50 -58 525 -40 -40 577 2700 -30 -22 632 ±7.0°C -20 -4 691 OHMS -10 14 754 2500 0 32 820 10 50 889 IN 2300 20 68 962 ±5.0°C 30 86 1039 RESISTANCE 2100 40 104 1118 50 122 1202 1900 6 70 0 1 14 50 8 1 12 38 78 9 ±4.0°C 80 176 1472 1700 90 194 1569 SENSOR 100 212 1670 ±3.0°C 1500 110 230 1774 120 248 1882 130 266 1993 ±2.0°C 1300 140 284 2107 TEMPERATURE 150 302 2225 1100 183 361 2628 ±1.6°C 900 700 LOW PT ±3.0°C 500 SUMP TEMPERATURE IN °F 4 32 68 104 140 176 212 248 284 320 356 -60 -40 --20 0 20 40 60 80 100 120 140 160 180 SUMP TEMPERATURE IN °C V01602.01 Figure 6–12. Temperature Sensor Chart 4.

Check the sensor wires in the external harness for opens (code 33 23), shorts between wires, or shorts-to-ground (code 33 12 — refer to Section 4). If wiring problems are found, isolate and re- pair as described in Appendix E. 5. If no harness problems are found, check the feedthrough harness for damage. If the feedthrough harness connector is satisfactory, drain the fluid and remove the control module. Check for chafing of the sensor wires, especially near the separator plate. Eliminate the chafe point. If no chafe point is found, replace the sensor (refer to the Transmission Service Manual and Appendix E, Paragraph 1–12 in this manual). 6.

If the problem recurs, use a spare wire, if available, or provide a new wire (St. Clair P/N 200153 may be used for this purpose) for the temperature sensor circuit. CAUTION: Using an unmatched ECU/CIN combination may result in additional codes being set or in transmission clutch damage. Using an ECU from another vehicle is not a recommended procedure where the test will involve driving the vehicle. This is because the stored adaptive information is tuned to the original vehicle's transmission and those adaptive settings may not perform as expected in another vehicle. Transmission performance could be worse and damage to the clutches may occur. NOTE:

If using an ECU from another vehicle is unavoidable, the ECU must be set to unadapted shifts and the vehicle must be driven carefully to adapt the shifts to the test vehicle. Refer to Service Information Letter 16-WT-96 for the correct procedure. Be sure to reset the ECU to unadapted shifts when it is returned to the original vehicle. 7. If the condition persists, replace the ECU with a test diagnostic ECU (P/N must match and it is recommended that the controller be loaded with the latest version of the CIN). If replacing the ECU corrects the problem, reinstall the original (bad) ECU to confirm that the problem is in the ECU.

If the original ECU now works, inspect the ECU connectors for corrosion or damage which may cause an intermittent condition. If the original problem recurs, install a replacement ECU.