Isuzu — Chart B-1-1 With the key in the ON position (Before starting the engine). Warning light (W/L) is not activated.

ANTI-LOCK BRAKE SYSTEM (ABS) 5A4-39 Chart B-1-1 With the key in the ON position (Before starting the engine). Warning light (W/L) is not activated. Step Action Value(s) Yes No 1 Is W/L fuse F-12 disconnected? - Go to Step 5 Go to Step 2 2 Is W/L burnt out? - Go to Step 6 Go to Step 3 3 1. Turn the key off. 2. Disconnect EHCU connectors. 3. Turn the key on. 4. Using DVM, measure the voltage between J-500 EHCU connector terminals 6 and 1. Does the DVM display a voltage within the specified value? 12V: 9.5-16.5V 24V: 16.5-34V Go to Step 4 Go to Step 7 4 Check the continuity between J-500 EHCU connector terminal 1 and body ground. Is there continuity?

- Go to Step 9 Go to Step 8 5 Replace the fuse. Is action complete? - Go to Step 10 - 6 Replace the W/L bulb. Is action complete? - Go to Step 10 - 7 Locate and repair open circuit, poor connection or short circuit in the ignition feed circuit. Is action complete? - Go to Step 10 - 8 Locate and repair open circuit, poor connection or short circuit in the ground circuit. Is action complete? - Go to Step 10 - 9 1. Check the harness for suspected disconnection. 2. If no fault found, replace the EHCU. Is action complete? - Go to Step 10 - 10 1. Reconnect all components, ensure all components are properly mounted. 2. Clear diagnostic trouble code. Was this step finished?

- Go to “Basic diagnostic flow chart.” -