5A4-40 ANTI-LOCK BRAKE SYSTEM (ABS) Chart 1 (DTC13/C0213) Vehicle Type Error Chart 2 (DTC14/C0214) Low Power Voltage of Rear Sensor or EHCU Abnormality Step Action Value(s) Yes No 1 1. Disconnect EHCU connector. 2. Turn the key on. 3. Measure the voltage at terminal 14, 15, and 17. NQR: All terminal battery voltage NKR, NPR: All terminal 0V Go to Step 2 Go to Step 5 2 1. Turn the key off and connect EHCU. 2. Connect the TECH 2. 3. Clear the vehicle type. 4. Does the warning light turn off? - Go to Step 3 Replace the EHCU. Go to Step 3 3 Confirm the vehicle type. Is the vehicle type okay? - Go to Step 4 Replace the EHCU. Repeat Step 3 4 Clear the DTC. - Troubleshooting completed.
- 5 Repair harness. Does the warning light turn off? - Go to Step 3 Replace the EHCU. Go to Step 3 Step Action Value(s) Yes No 1 Perform chart 11 and 12. - Go to Step 2 Go to Step 1 2 1. Turn the key off. 2. Disconnect the EHCU connector. 3. Measure continuity between the body ground and J-500 connector terminal 1, 23. Is there continuity? - Go to Step 3 Go to Step 4 3 1. Connect the EHCU connector. 2. Clear DTC. 3. Turn the key from off to on and perform diagnosis procedure. Does the DTC repeat? - Go to Step 5 Go to Step 6 4 Repair the open/short circuit or malfunction at connection of connector. Is this step completed? - Go to Step 6 - 5 Replace the EHCU. Is this step completed?
- Go to Step 6 - 6 1. Install all parts. Verify each part is properly installed. 2. Clear DTC. Is this step completed? - Go to “Basic diagnostic flow chart”. Go to Step 6