ANTI-LOCK BRAKE SYSTEM (ABS) 5A4-41 Chart 3 (DTC15/C0215) EHCU Voltage OUT of Range Step Action Value(s) Yes No 1 Is the battery voltage okay? - Go to Step 2 Go to Step 5 2 1. Turn the key off. 2. Disconnect the EHCU connector. 3. Start the engine. 4. Measure voltage between J-500 connector terminal 2 and J-500 connector terminal 1, 23. Is the voltage within the specified value? 12 V vehicle: 10-16 V 24 V vehicle: 17-33.5 V Go to Step 3 Go to Step 6 3 Locate the malfunction of connection in the circuit. Is the circuit malfunction specified? - Go to Step 4 Go to Step 8 4 Repair the malfunction and perform diagnosis procedure. Does the DTC repeat?
- Go to Step 7 Go to Step 8 5 Charge or replace the battery. Is this step completed? - Go to Step 8 - 6 Repair open/short circuit or malfunction at connection of connector between J-500 connector terminal 2 and fusible link FL-4. Is this step completed? - Go to Step 8 - 7 Replace the EHCU. Is this step completed? - Go to Step 8 - 8 1. Install all parts. Verify each part is properly installed. 2. Clear DTC. Is this step completed? - Go to “Basic diagnostec flow chart”. Go to Step 8