Isuzu — Chart 13 (DTC 61/C0261) Abnormal FL Speed Sensor Signal

5A4-46 ANTI-LOCK BRAKE SYSTEM (ABS) Chart 13 (DTC 61/C0261) Abnormal FL Speed Sensor Signal Step Action Value(s) Yes No 1 Is there play in the FL wheel bearing? - Go to Step 10 Go to Step 2 2 Is there play in the FL speed sensor/sensor rotor? - Go to Step 11 Go to Step 3 3 Is there powdered iron sticking to FL speed sensor/sensor rotor? - Go to Step 12 Go to Step 4 4 Check the FL speed sensor. (Refer to Chart C- 1-1 or TC-1) Is the FL sensor output normal? - Go to Step 5 Go to Step 8 5 Is there a broken tooth or indentation in the sensor rotor? - Go to Step 13 Go to Step 6 6 Using DVM, measure the resistance between J-500 EHCU connector terminal 33 and ground.

Does the DVM display a resistance within the specified value? 1000 k ohms or more Go to Step 7 Go to Step 9 7 1. Clear diagnostic trouble code. 2. Test drive and perform system self-check. Does repeat trouble? - Go to Step 18 Go to Step 16 8 Is there damage or indentation in the speed sensor? - Go to Step 14 Go to Step 15 9 1. Disconnect FL sensor connector. 2. Using DVM, measure the resistance between J-75 sensor connector terminal 2 and ground. Does the DVM display a resistance within the specified value? 1000 k ohms or more Go to Step 17 Go to Step 14 10 Adjust wheel bearing preload. Is action complete? - Go to Step 19 - 11 Repair or replace speed sensor/sensor rotor. Is action complete?

- Go to Step 19 - 12 Repair speed sensor/sensor rotor. Is action complete? - Go to Step 19 - 13 Replace sensor rotor. Is action complete? - Go to Step 19 - 14 Replace FL speed sensor. Is action complete? - Go to Step 19 - 15 Check the FL speed sensor circuit. Refer to Chart 9. Is action complete? - Verify repair 16 Check for a poor connection and an open circuit on the harness between EHCU and sensor connectors. Refer to “Note on Intermittents” described in earlier this section. Is action complete? - Go to Step 19 -