Isuzu — Chart C-1-4 RR Speed Sensor Output Inspection Procedure

ANTI-LOCK BRAKE SYSTEM (ABS) 5A4-57 Chart C-1-4 RR Speed Sensor Output Inspection Procedure Step Action Value(s) Yes No 1 1. Turn the key off. 2. Disconnect EHCU connector. 3. Jack up the vehicle, with all wheels off the ground. 4. Connect a 120 ohms resistor between J-500 EHCU connector terminal 21 and ground. 5. Using DVM, measure the DC voltage between J-500 connector terminal 21 and ground while turning RR wheel at a speed of 0.5 RPS. Does the DVM display a voltage within the specified value? 0.2-4.5V Go to Step 5 Go to Step 3 2 1. Turn the key off. 2. Disconnect RR sensor connector. 3. Connect a 120 ohms resistor between sensor connector terminal 2 (sensor side) and ground. 4.

Apply 12V voltage at sensor connector terminal 1 (sensor side). 5. Using DVM, measure the DC voltage between sensor connector terminal 2 (sensor side) and ground while turning RR wheel at a speed of 0.5 RPS. Does the DVM display a voltage within the specified value? 0.2-4.5V Go to Step 3 Go to Step 4 3 1. Locate open circuit, poor connection short circuit on the harness between EHCU and sensor connectors. 2. Repair the harness. Is action complete? - Go to Step 5 - 4 Replace RR sensor. Is action complete? - Go to Step 5 - 5 1. Reconnect all components, ensure all components are properly mounted. 2. Clear diagnostic trouble code. Was this step finished?

- Go to “Basic diagnostic flow chart.” Go to Step 5