Isuzu — Chart TC-1 Sensor Output Inspection Procedure (Use TECH 2)

5A4-58 ANTI-LOCK BRAKE SYSTEM (ABS) Legend (1) Battery (4) Speed Sensor (2) DVM (3) Resistor Chart TC-1 Sensor Output Inspection Procedure (Use TECH 2) Step Action Yes No 1 1. Connect TECH 2. 2. Check the minimum speed of each sensor by WHEEL SENSORS. Is the sensor speed more than 5km/h (3mph)? Go to Step 2 Go to Step 6 2 Check the sensor harness for suspected disconnection (check while shaking harness/connector). Is the sensor harness connection normal? Replace speed sensor. Go to Step 3 Repair. Go to Step 3 3 Check the minimum speed of each sensor by WHEEL SENSORS. Is the sensor speed more than 5 km/h (3mph)? Go to Step 4 Go to Step 6 4 Check the sensor rotor. Is the sensor rotor normal?

Go to Step 5 Replace sensor rotor. Go to Step 5 5 Check the minimum speed of each sensor by WHEEL SENSORS. Is sensor speed more than 5 km/h (3 mph)? Repair harness or connector between EHCU and speed sensor. Go to Step 6 Go to Step 6 6 Reconnect all components, ensure all components are properly mounted. Was this step finished? Repeat the “Basic diagnostic flow chart.” Go to Step 6