. MAINTENANCE SERVICE PROCEDURE CHANGE OIL IN ENGINE OIL PAN, REPLACE ENGINE OIL FILTER CARTRIDGE (including engine by-pass filter cartridge) WARNING is excessive metal particles or 4 - 58 EVERY 500 HOURS SERVIC Maintenance for every 250 hours should be performed at the sam e time. The oil is at high temperature after the engine has been operated, so never change the oil immediately afte r finishing operations Wait for the oil to cool down before ch Refill capacity: 50 liters (13.2 U Prepare a socket wrench and fi 1. Remove the covers at the b machine and on the side fac ottom left at the front of the e, and put a container directly d oil. osen drain valve (2) slowly to nd drain the oil.
in valve (2) so much that the orted. g (1) : 68.6 ± 9.81 Nm (7 ± 1 kgm, 50.6 ± 7.2 lbft) underneath to catch the draine 2. Remove drain plug (1) and lo avoid getting oil on yourself, a Take care not to loosen dra stopper pin in the valve is dist Tightening torque for drain plu Tightening torque for drain val avoid getting oil on yourself, a Take care not to loosen dra stopper pin in the valve is dist Tightening torque for drain plu Tightening torque for drain val ve (2): 63.7 ± 14.7 Nm (6.5 ± 1. 5 kgm, 47.0 ± 10.8 lbft) 3. Check the drained oil, if there foreign material, contact your 4. Tighten drain valve (2), then ti 5.
Open up the left engine side co ver, remove the two bolts on the inside and open the lower cov hinges. er outward on the intermediate 6. Using the filter wrench, turn en gine oil filter cartridge (3) to the left and remove it.