. MAINTENANCE SERVICE PROCEDURE EVERY 1000 HOURS SERVICE REPLACE FUEL MAIN FILTER CARTRIDGE WARNING 3. Using a filter wrench, turn filter cartridge (2) counterclockwise to remove it. 4 - 64 Maintenance f or every 250 and 500 ho urs service should b e carried out at the sam After the eng ine has been operated, all pa rts are at high temperature, so do not replace the f ilter immediately. Wait for all parts to cool down before starting the operatio n. gine fuel piping system when the engine is running.
High pressur e is generated inside the en gine fuel piping system when the engine is runni When replac ing the filter, wait for at leas t 30 seconds after stopping the engine to let the internal pressure go dow n before replacing the filter. any fire or flame close. hen opening the air bleed plug in the fuel filter head. It is still under pressure, so fuel may spurt out. Do not bring Be careful w hen opening the air bleed pl ug in the fuel filter head . It is still under pressure NOTICE Genuine Ko matsu fuel filter cartridges u se a special filter that has highly efficient filterin g ability. When replacing t he filter cartridge, alw ays use a genuine Komats u part.
The common rail fuel injection system u sed on this machine co nsists of more precise pa rts than the conventional i njection pump and no zzle. If any part ot her than a genuine Komatsu filter cartridge is used, dust or dirt may get in and cause problems with the i njection system. Alw ays avoid using substitute p arts. When carryin g out inspection or mainten ance of the fuel system , pay more attention than normal to the entry of dirt. If dirt is stuck to any part, use fuel to wash it off completely. Container t Prepare a f 1. Set the co ntainer under the filter ca rtridge to catch the d oil. 2. Close valv e (1) of fuel strainer part