Brakes 42 Brake Chamber Stroke Specifications Chamber Max Applied Stroke: inch (mm) Manufacturer Type * Size Dana Spicer Long Stroke 16L 2 (51) 20L 24L 24LS 2-1/2 (64) 30LS * Long stroke design is indicated by a tag, or embossing, on the brake chamber. Specifications are relative to a brake application with 80 to 90 psi (550 to 620 kPa) air pressure in the brake chambers. If type 36 chamber is used, slack length should be less than 6 inches. Table 1, Brake Chamber Stroke Specifications 5. Start the engine and build air pressure to at least 100 psi (689 kPa). Shut down the engine. 6. Check all of the foundation brake components for damage, wear, and loose or missing parts. Re- pair as needed.
See Group 42 of the vehicle Workshop Manual for repair procedures. 1 42–06 Meritor Camshaft Bracket Lubrication 3 2 IMPORTANT: Perform a brake inspection before lubricating the camshaft bracket. NOTE: If equipped with an extended- maintenance Q Plus brake system, the cam- shaft bracket will not have a grease fitting. These camshafts use a special NLGI Grade synthetic polyurea grease and do not require lubrication for 3 years or 500,000 miles (800 000 km), whichever comes first. The extended- maintenance camshaft bushings are lubricated during the brake reline service interval. For ser- vice and lubrication instructions, see Group 42 of the vehicle Workshop Manual. f420011a 05/28/93 A A.
Grease Exit 1. Brake Chamber 2. Slack Adjuster 3. Non-Pressure-Relief Grease Fitting Fig. 5, Camshaft Bracket Lubrication WARNING If grease leaks out under the camhead, the cam- shaft bracket grease seal is worn or damaged. See Group 42 in the vehicle workshop manual for grease seal replacement instructions. If this seal is not replaced, the brake linings could become contaminated with grease. The stopping distance of the vehicle will be increased, which could result in personal injury or property damage. For camshaft brackets with grease fittings, use an NLGI Grade 1 or Grade 2 multipurpose chassis grease.
Lubricate the camshaft bushings through the grease fitting on the camshaft bracket or the spider until new grease flows from the inboard seal. See Fig. 5 . 122SD and Coronado 132 Maintenance Manual, February 2016 42/8