Brakes 42 42–07 Meritor Slack Adjuster Lubrication 1 IMPORTANT: Perform a brake inspection follow- ing the instructions in this group before lubricat- ing the slack adjusters. 2 3 WARNING 4 Failure to lubricate slack adjusters could lead to dragging brakes or a brake failure, resulting in property damage, personal injury, or death. 5 NOTE: If equipped with an extended- maintenance Q Plus brake system, the slack adjuster will not have a grease fitting. These slack adjusters use a special NLGI Grade syn- thetic polyurea grease and do not require lubri- cation for 3 years or 500,000 miles (800 000 km), whichever comes first.
The extended- maintenance slack adjusters are lubricated dur- ing the brake reline service interval. For service and lubrication instructions, see Group 42 of the vehicle Workshop Manual. 7 f420012a 10/20/93 1. Brake Chamber 2. Clevis 3. Actuator Rod 4. Boot 5. Pressure-Relief Capscrew, Gasket, Pawl Spring, and Pawl 6. Manual Adjusting Nut 7. Grease Fitting (or plug) 6 Fig. 6, Meritor Automatic Slack Adjuster For slack adjusters with grease fittings and for oper- ating temperatures above (–40°C), use an NLGI Grade 1 clay-base grease, or an NLGI Grade 1 or 2 lithium-base grease. Use an NLGI Grade 1 or Grade 2 multipurpose chas- sis grease.
If grease leaks out under the camhead, the camshaft bracket grease seal is worn or dam- aged; replace it. See Group 42 of the 122SD and Coronado Workshop Manual for grease seal replace- ment instructions. For slack adjusters with grease fittings and for oper- ating temperatures below (–40°C) and above (–54°C), use an NLGI Grade 2 synthetic oil, clay-base grease. Lubricate the slack adjuster at the grease fitting until grease is forced past the pressure-relief capscrew or past the gear splines around the inboard snap ring. See Fig. 6 . 42–09 Dana Spicer, Haldex, and Gunite Slack Adjuster Lubrication 42–08 Dana Spicer Camshaft Bracket Lubrication IMPORTANT:
Perform a brake inspection before lubricating the camshaft bracket. Automatic slack adjusters that have a grease fitting must be lubricated periodically to ensure proper brake operation. IMPORTANT: Perform a brake inspection before lubricating the camshaft bracket. WARNING Pump grease into the camshaft bracket until it ap- pears at the slack adjuster end of the bracket. See Fig. 5 . Failure to lubricate slack adjusters could lead to dragging brakes or a brake failure, resulting in property damage, personal injury, or death. 122SD and Coronado 132 Maintenance Manual, February 2016 42/9