Brakes 42 Dana Spicer and Haldex WARNING Do not use moly-disulfide-loaded grease or oil. Both the life and reliability of the slack adjuster will be reduced if this type of grease is used, which could lead to brake failure, resulting in property damage, personal injury, or death. Lubricate the automatic slack adjuster at the grease fitting. See Fig. 7 for a Dana Spicer slack adjuster. Dana Spicer Low Lube slack adjusters should be lu- bricated with SHC 460 synthetic lubricant. See Fig. 8 for a Haldex slack adjuster. Use standard chassis lubricant for Haldex slack adjusters. 1 f422363c 06/26/2007 Fig.
8, Haldex Automatic Slack Adjuster Grease Fitting Lubricate a Gunite automatic slack adjuster at the grease fitting until grease appears on the camshaft, or flows from the grease relief. See Fig. 9 . 2 The newest Gunite automatic slack adjusters are produced without a grease relief. During lubrication with a grease gun, lubricant is forced through the drilled worm wheel onto the camshaft. Lubricate the automatic slack adjuster at the grease fitting until grease appears on the camshaft. 02/01/2001 f421649a 1. Grease Fitting 2. Slack Adjuster 42–10 Bendix E-6 Foot Control Valve Inspection and Lubrication Fig.
7, Dana Spicer Automatic Slack Adjuster Gunite For operating temperatures of (–29°C) and higher, use Texaco Multifak EP-2 or Mobil Grease No. 77. 1. Remove the brake valve from the vehicle; see Group 42 , of the vehicle Workshop Manual. 2. Remove the roll pin from the brake pedal pivot pin. See Fig. 10 . For operating temperatures between (–29°C) and (–40°C), use Lubriplate Aero grease. 3. Remove the brake pedal pivot pin. 4. Remove the brake pedal. 122SD and Coronado 132 Maintenance Manual, February 2016 42/10