Freightliner — 122SD, Coronado 132

Brakes 42 2 5 4 5 6 1 6 3 4 7 8 3 7 8 2 9 1 09/10/2004 f430405 1. E-6 Foot Control Valve 2. Mounting Plate 3. Nut and Washer 4. Pivot Pin 5. Roll Pin 6. Roller 7. Roller Pin 8. Pedal 10 Fig. 10, Brake Pedal and Valve Assembly 10/27/93 1. 7/16-Inch Adjusting Nut 2. Grease Fitting 3. Boot 4. Link 5. Brake Chamber Piston Rod 6. Clevis 7. 1/2-Inch Clevis Pin 8. 1/4-Inch Clevis Pin 9. Grease Relief Opening 10. Slack Adjuster Spline f420653a 9. Lubricate the plunger with barium grease (BW 246671). 10. Insert the plunger in the valve. 11. Install the brake pedal with the pivot pin. 12. Install a new roll pin and apply Torque Seal (OPG F900 White) to the roll pin. Fig.

9, Gunite Automatic Slack Adjuster 13. Install the brake valve assembly; see Group 42 , of the vehicle Workshop Manual. 5. Check the brake pedal mounting plate adapter for signs of wear or cracks at the bosses (the area from which the pivot pin was removed). Re- place it if necessary. 14. Test the brakes before returning the vehicle to service. 42–11 WABCO System Saver Air Dryer Desiccant Cartridge Replacement 6. Check the brake pedal rollers for signs of wear or cracks. Replace the rollers as needed. 7. If the rollers are replaced, replace the roller pin, install a new cotter pin, bend it to 90 degrees and apply Torque Seal (OPG F900 White) to the cotter pin. NOTE:

The following instructions apply to the System Saver 1200, 1200 Plus, and Twin air dryers. 8. Remove the plunger from the valve. Using alco- hol, clean the existing grease from the plunger. Check the plunger for signs of wear or cracks. Replace it if necessary. NOTICE The WABCO System Saver air dryers can use ei- ther a standard or oil coalescing desiccant car- 122SD and Coronado 132 Maintenance Manual, February 2016 42/11