Steering 46 46–00 Safety Precautions If there is 1/8-inch (3-mm) movement or more, do not drive the vehicle until the drag link is replaced. Safety Precautions in this section apply to all procedures within this group. 46–02 Power Steering Fluid and Filter Changing DANGER When working on the vehicle, shut down the en- gine, set the parking brake, and chock the tires. Before working under the vehicle, always place jack stands under the frame rails to ensure the vehicle can not drop. Failure to follow these steps could result in serious personal injury or death. WARNING Fill only with approved clean fluid. Failure to use the proper fluid could cause seal deterioration and leaks.
Fluid leaks could eventually cause loss of power steering assist. This could lead to an acci- dent resulting in personal injury or property dam- age. Wear eye protection when changing the fluid and filter. 46–01 Drag Link Inspection WARNING 1. Park the vehicle on a level surface, shut down the engine, apply the parking brakes, and chock the rear tires. All steering system components are critical for safe operation of the vehicle. Failure to maintain the steering system as specified may result in loss of steering control, which could lead to per- sonal injury and property damage. 2. Place a drain pan under the power steering res- ervoir. 3. Remove the retaining ring from the reservoir. See Fig.
1 . WARNING 2 3 4 All steering system components are critical for safe operation of the vehicle. Failure to maintain the steering system as specified may result in loss of steering control, which could lead to per- sonal injury and property damage. 1 Have someone turn the steering wheel from left to right. Check for movement between the ball stud end at both the pitman arm and the steering arm. Also check if the ball stud nut is loose. If the ball stud end is loose, replace the drag link. If the ball stud nut is loose, replace the nut and cotter key. See Group 46 of the vehicle Workshop Manual for drag link removal and installation instructions.
See Group 00 in this manual for torque specifica- tions. 10/19/2001 f461917 1. Power Steering Reservoir 2. Retaining Ring 3. Filter Cover 4. Return Hose Inspect the boot of the drag link at both the pitman arm and the steering arm end for cracks, splits, or other damage. Replace the boot as needed. Fig. 1, Power Steering Reservoir Grasp the drag link near the pitman arm end, then push and pull laterally to check for axial movement in the ball stud end. If it is loose, replace the drag link. 4. Remove the filter, filter cover, and gasket from the reservoir. Drain the fluid from the filter into 122SD and Coronado 132 Maintenance Manual, February 2016 46/1