Freightliner — 122SD, Coronado 132

Steering 46 the drain pan. Leave the filter hanging over the drain pan. 15. Start the engine and check that the power steer- ing fluid level is between the MIN COLD and MAX HOT lines. Add more power steering fluid if needed. 5. Remove the nuts, bolts, and washers that attach the power steering reservoir to the mounting bracket, but do not remove the supply line to the reservoir. Drain the power steering fluid from the reservoir. 16. Raise the vehicle, remove the jack stands, and lower the vehicle. 6. Using bolts, nuts, and washers, attach the reser- voir to the mounting bracket. 46–03 Power Steering Fluid Level Inspection 7.

Fill the reservoir with an approved power steer- ing fluid to the line between the MIN COLD and MAX HOT lines. See Fig. 1 . See Table 1 for ap- proved power steering fluids. 1. Apply the parking brakes and chock the tires. 2. With the engine cool, use a shop towel or a clean rag to clean the area around the power steering reservoir fill cap. Twist the cap counter- clockwise to remove it. Check the cold power steering fluid level. The level should be between ADD COLD and FULL COLD with the engine off. Fluid Type Approved Fluid Approved Power Steering Fluids Dexron® III Automatic Transmission Fluid Super ATF 3. Start the engine and run it at idle until it reaches operating temperature.

See Table 1 for recom- mended power steering fluids. Table 1, Approved Power Steering Fluids TES-389 8. Raise the front of the vehicle and support it with jack stands. Remove the dipstick, and check that power steering fluid is between ADD HOT and FULL HOT. If the fluid level is low, add enough fluid to bring the level up to the FULL HOT mark on the dipstick. 9. Start the engine and operate it at idle. Turn the steering wheel from full left to full right several times until clean fluid starts flowing from the power steering filter. Add fluid to the reservoir to maintain the fluid level between the MIN COLD and MAX HOT lines. 46–04 Power Steering Gear Lubrication 10. Shut down the engine. NOTE:

Always install a new power steering res- ervoir filter when changing the fluid. NOTICE 11. Disconnect the filter from the filter cover, and dis- card the filter. Apply grease to the sector shaft with a hand-type grease gun only. Use of a high-pressure power grease gun will supply grease too quickly and could affect the high pressure seal, contaminating the hydraulic fluid. 12. Apply a thin film of power steering fluid on the gasket of the new filter. Then attach the filter to the filter cover. Hand-tighten the filter, then turn it an additional 1/4 turn. Using a hand-type grease gun, apply NLGI Grade 2 or 3 multipurpose chassis grease until it starts to come out past the sector shaft seal. See Fig. 2 .

13. Install the filter and filter cover in the reservoir. Make sure that the gasket under the filter cover is not damaged. If the gasket is damaged, re- place it. Install the gasket on the reservoir. 46–05 Drag Link Lubrication 14. Attach the retaining ring to the reservoir to se- cure the filter and filter cover. 1. Park the vehicle on a level surface, shut down the engine, and set the parking brake. Chock the tires. 122SD and Coronado 132 Maintenance Manual, February 2016 46/2