Fuel 47 47–00 Safety Precautions 2. Disconnect the water sensor and heater connec- tions if equipped. Safety Precautions in this section apply to all procedures within this group. 3. Remove the element and bowl together, by turn- ing counterclockwise. DANGER 4. Remove the bowl from the element and clean the O-ring land. When working on the vehicle, shut down the en- gine, set the parking brake, and chock the tires. Before working under the vehicle, always place jack stands under the frame rails to ensure the vehicle can not drop. Failure to follow these steps could result in serious personal injury or death. 5. Apply a coating of clean fuel or motor oil to the new O-ring and element seal. 6.
Spin the bowl onto the new element, then spin them both onto the filter head, snugly, by hand only. IMPORTANT: Do not use tools to tighten the bowl and element. 47–01 Fuel Filter Replacement 7. Connect the water sensor and heater connectors if equipped. For engine-mounted fuel filter replacement, refer to the engine manufacturer’s service manual for re- moval and installation procedures. 8. If equipped with a primer pump, prime the fuel/water separator as follows. 47–02 Fuel/Water Separator Element Checking and Replacement 8.1 Loosen the vent plug. Then operate the primer pump until the fuel purges at the vent plug. See Fig. 1 . 8.2 Close the vent plug. 9.
Start the engine and check for fuel leaks. Alliance/Racor 10. Shut down the engine and correct any fuel leaks. Davco Fuel Pro® 382 and 482 The only maintenance necessary on an Alliance or Racor fuel/water separator is to replace the filter element. WARNING WARNING Fluid circulated through the fuel/water separator to heat the fuel may be diesel fuel returned from the engine, or engine coolant. Drain the fuel/water separator only when the engine and fluids have cooled. Draining it when the engine is hot could cause severe personal injury due to scalding. Fluid circulated through the fuel/water separator to heat the fuel may be diesel fuel returned from the engine, or engine coolant.
Drain the fuel/water separator only when the engine and fluids have cooled. Draining it when the engine is hot could cause severe personal injury due to scalding. If returning fuel is released into the atmosphere, its vapors can ignite in the presence of any igni- tion source. Do not expose the fuel to, or work with the fuel system near, open flame or intense heat. To do so could cause fire, possibly resulting in serious personal injury or property damage. If returning fuel is released into the atmosphere, its vapors can ignite in the presence of any igni- tion source. Do not expose the fuel to, or work with the fuel system near, open flame or intense heat.
To do so could cause fire, possibly resulting in serious personal injury or property damage. The filter element should be changed only when the fuel level has reached the top of the filter element. There is no significant restriction to fuel flow until the element is completely clogged. 1. Drain off some fuel by loosening the vent plug and opening the drain valve. 122SD and Coronado 132 Maintenance Manual, February 2016 47/1