Fuel 47 2 The drain valve has a 1/2-inch (12.7-mm) pipe; use a hose with a 1/2-inch pipe thread to fit cor- rectly. 3 1 4. Remove the vent cap ( Fig. 2 , Item 4) and open the drain valve ( Fig. 2 , Item 1) to drain the fuel completely, then close the drain valve. 4 11 3 5 10 5 2 9 6 7 6 8 1. Mounting Head 2. Fuel Primer Pump 3. Vent Plug 4. Bowl O-Ring 5. Bowl Gasket 6. Bowl Probe Plug 06/25/97 f470147 7. Water Sensor Probe 8. Heater Connector 9. Drain Plug 10. Sight Bowl 11. Filter Element f470506b 05/05/2009 1. Drain Valve 2. Lower Housing 3. Clear Cover 4. Vent Cap 5. Collar 6. Inlet Port/Check Valve Fig. 1, Alliance Fuel/Water Separator Fig.
2, DAVCO Fuel/Water Separator (Fuel Pro 382 Shown) 1. Shut down the engine, apply the parking brake, and chock the tires. 5. Using a DAVCO Collar Wrench ( Fig. 3 ), remove the clear cover and collar. 2. Check the fuel level in the fuel filter. Replace the fuel/water separator element only when the filter element is completely covered. If the fuel level has reached the top of the filter element, follow the procedure below to replace the element. NOTE:
In the event of an emergency, when the filter needs replacement but a Davco filter is not available for the Fuel Pro 382, a temporary filter can be used; see the procedure under the heading "Emergency Temporary Filter Replace- ment, Fuel Pro 382." VENT CAP FOR REMOVAL OF TOP COLLAR ONLY 02/16/2009 f470277 3. Put a clean receptacle under the fuel/water sepa- rator and attach a piece of hose to the drain valve, to direct fuel into the receptacle. Fig. 3, DAVCO Collar Wrench NOTE: Broken vent cap and collar warranty claims will not be accepted if any tool other than a DAVCO Collar Wrench is used for removal.
During installation, the vent cap and collar are 122SD and Coronado 132 Maintenance Manual, February 2016 47/2 4 1