Freightliner — 122SD, Coronado 132

Fuel 47 to be hand-tightened only , not tightened with a wrench. Use part number 482017 on Fuel Pro 482 units; part number 380134 on Fuel Pro 382 units. 11 6. Remove the filter, cover O-ring, and vent cap O-ring. Dispose of them in an environmentally acceptable manner. See Fig. 4 or Fig. 5. 10 9 7. Clean all threads and sealing surfaces very thor- oughly. Even a small amount of dirt will prevent the fuel/water separator from sealing, and an air leak may result. 8. On Fuel Pro 382 units, install the grommet on the bottom of the new filter. 8 9. Install the new filter and grommet assembly and cover O-ring on the housing. 10. Install the clear cover and the collar. Hand- tighten the collar. 7 11.

Prime the system 11.1 Ensure that the drain valve is closed. 11.2 Fill the housing to the top with clean die- sel fuel. 6 11.3 Install and hand-tighten the vent cap O-ring and vent cap. 11.4 Start the engine. When the lubricating oil reaches its normal operating pressure, increase engine speed to high idle for one to two minutes to purge air from the system. 5 4 11.5 While the engine is running, and after the air is purged from the system, loosen the vent cap until the fuel level falls to just above the collar, then hand-tighten the vent cap. 12 3 2 13 11.6 Check for leaks and shut down the en- gine. Emergency Temporary Filter Replacement, Fuel Pro 382 1 05/05/2009 f470531 1. Drain Valve 2.

Bottom Plate Assembly 3. Bottom Plate O-Ring 4. Lower Housing 5. Cover O-Ring 6. Filter Element 7. Spring 8. Clear Cover 9. Vent Cap O-Ring 10. Vent Cap 11. Collar 12. Inlet Port/Check Valve 13. Heat Exchanger WARNING Fluid circulated through the fuel/water separator to heat the fuel may be diesel fuel returned from the engine, or engine coolant. Drain the fuel/water separator only when the engine and fluids have Fig. 4, DAVCO Fuel Pro 382 122SD and Coronado 132 Maintenance Manual, February 2016 47/3