Freightliner — 122SD, Coronado 132

Fuel 47 cooled. Draining it when the engine is hot could cause severe personal injury due to scalding. 10 If returning fuel is released into the atmosphere, its vapors can ignite in the presence of any igni- tion source. Do not expose the fuel to, or work with the fuel system near, open flame or intense heat. To do so could cause fire, possibly resulting in serious personal injury or property damage. 9 8 1. Shut down the engine, apply the parking brake, and chock the tires. 2. Put a clean receptacle under the fuel/water sepa- rator and attach a piece of hose to the drain valve, to direct fuel into the receptacle.

7 The drain valve has a 1/2-inch (12.7-mm) pipe; use a hose with a 1/2-inch pipe thread to fit cor- rectly. 6 5 3. Remove the vent cap ( Fig. 2 , Item 4) and open the drain valve ( Fig. 2 , Item 1) to drain the fuel completely, then close the drain valve. 4. Using a DAVCO Collar Wrench ( Fig. 3 ), remove the clear cover and collar. 4 NOTE: Broken vent cap and collar warranty claims will not be accepted if any tool other than a DAVCO Collar Wrench, part number 380134, is used for removal. During installation, the vent cap and collar are to be hand-tightened only , not tightened with a wrench. 11 3 12 5. Remove the filter and dispose of it in an environ- mentally acceptable manner. 2 6.

Clean all threads and sealing surfaces very thor- oughly. Even a small amount of dirt will prevent the fuel/water separator from sealing, and an air leak may result. 7. Ensure that the drain valve is closed. 1 13 8. Remove the filter grommet from the filter stud, if equipped. 05/05/2009 f470530 1. Inlet Port/Check Valve 2. Lower Housing 3. Bypass Valve 4. Filter Element 5. Spring 6. Cover O-Ring 7. Clear Cover 8. Vent Cap O-Ring 9. Vent Cap 10. Collar 11. 120VAC Pre-Heater 12. 12VDC Pre-Heater 13. Drain Valve 9. Fill the housing to the top with clean diesel fuel. 10. Install a standard engine spin-on filter (part num- ber FF105 or equivalent) on the filter stud. 11.

Install the cover O-ring, clear cover, and the col- lar. Hand-tighten the collar. Fig. 5, DAVCO Fuel Pro 482 12. Install and hand-tighten the vent cap O-ring and vent cap. 122SD and Coronado 132 Maintenance Manual, February 2016 47/4