Heater and Air Conditioner 83 83–00 Safety Precautions 1 Safety Precautions in this section apply to all procedures within this group. 2 DANGER A When working on the vehicle, shut down the en- gine, set the parking brake, and chock the tires. Before working under the vehicle, always place jack stands under the frame rails to ensure the vehicle can not drop. Failure to follow these steps could result in serious personal injury or death. 83–01 Air Conditioner Inspection 01/13/2010 f831825 A. Gap Dimension: 0.014 to 0.024 inch (0.35 to 0.60 mm) 1. Hub 2. Rotor Magnetic Clutch NOTE: The following procedure applies to an air conditioner system with a Denso compressor. Fig.
1, Hub/Rotor Gap WARNING 83–02 Air Filter Replacement The HVAC system has three filters that must be re- placed periodically to maintain proper system opera- tion. The cabin fresh-air-intake filter is accessed from under the hood, and the recirculation filter is ac- cessed from inside the cab. The sleeper air filter is located under the bunk. Cab Fresh Air Filter Replacement Wear eye protection, gloves, and protective cloth- ing when working on the air conditioning system. Leaking refrigerant from a damaged hose or line could cause blindness or serious skin burns. 1. Park the vehicle on a level surface, apply the parking brakes, and chock the tires. 2. Inspect the A/C compressor hub.
A torn or melted rubber dampener (center section) indi- cates internal damage has occurred within the compressor. Inspect friction surfaces for wear, oil-soaked condtions, or discoloration due to ex- cessive heat. NOTICE If equipped with a fresh air filter, it should be re- placed every six months, more often if the vehicle is operated under extreme conditions. If the fresh air filter is not replaced at proper intervals, dam- age to the heater and air conditioner components could occur. IMPORTANT: When replacing the air filter, use only a Freightliner-approved air filter. 3. With the belt removed, check to make sure that the rotor (pulley) spins freely.
It should not wobble or make contact with the hub when it is spinning. The average air gap between the hub and rotor should be 0.014 to 0.024 inch (0.35 to 0.6 mm). Check the gap at several locations and average the results. See Fig. 1. 1. Apply the parking brakes and chock the tires. 4. Check the overall condition of the air conditioning hoses. Look for cracks, cuts, and abrasions on the hoses. Replace damaged hoses. For re- placement instructions, see Group 83 of the 122SD and Coronado Workshop Manual . Also check for signs of loose fittings on all of the air conditioning components. 2.
Lift the wire retainer on the air filter cover up and over the upper edge of the cover and pull the wire retainer down; see Fig. 2 . 3. Note the direction of the arrow on the air filter cover, then remove the cover and the attached filter. 122SD and Coronado 132 Maintenance Manual, February 2016 83/1