Heater and Air Conditioner 83 should not be operated without the recirculation air filter installed. IMPORTANT: When replacing the air filter, use only a Freightliner-approved air filter. 1. Park the vehicle on a level surface. Apply the parking brakes and chock the rear tires. 2. Remove the dash lower console. The lower con- sole is secured by nine Torx screws; see Fig. 3 . 3. Remove the retainer that holds the recirculation air filter in place; see Fig. 4 . 2 4. Remove and discard the recirculation air filter. 5. Install a new recirculation air filter in the retainer. 6. Install the retainer in the HVAC assembly; see Fig. 4 . 1 7. Install the dash lower console.
Tighten the Torx screws 24 to 30 lbf·in (270 to 340 N·cm). See Fig. 3 . 09/11/2009 f831822 Sleeper Air Filter Replacement 1. Air Filter Cover 2. Wire Retainer Replace the air filter in the sleeper HVAC unit every six months, regardless of mileage. The filter should not be cleaned. Fig. 2, HVAC Air Intake Plenum 4. Remove the air filter from the air filter cover. Dis- card the air filter. NOTICE 5. Attach a new air filter to the air filter cover. Make sure the arrow on the filter is pointing in the same direction as the arrow on the cover. If the sleeper air filter is not replaced every six months, damage to the heater and air conditioner components could occur.
The HVAC system should not be operated without the recirculation air filter installed. 6. Install the air filter and air filter cover in the HVAC air intake plenum. 7. Pull the wire retainer up and over the upper edge of the air filter cover. Cab Recirculation Air Filter Replacement 1. Turn off the engine, apply the brakes, and chock the tires. 2. Access the sleeper HVAC assembly by raising the mattress and bunk panel to the locked posi- tion. If there is a baggage compartment, the sleeper HVAC assembly may be accessed through the baggage door on the right side of the vehicle.
The cab recirculation air filter must be replaced every six months, regardless of mileage, to permit proper operation of the HVAC system. The filter can be ac- cessed by removing the dash lower console. See Fig. 3 . 3. Slide the air filter out of the sleeper HVAC as- sembly; see Fig. 5 . NOTICE 4. Place a new air filter in the sleeper HVAC as- sembly. The edge of the filter should be flush with the HVAC assembly. If the recirculation air filter is not replaced every six months, damage to the heater and air condi- tioner components could occur. The HVAC system 122SD and Coronado 132 Maintenance Manual, February 2016 83/2