Engine Cooling/Radiator 20 20–00 Safety Precautions 2 Safety Precautions in this section apply to all procedures within this group. DANGER 3 When working on the vehicle, shut down the en- gine, set the parking brake, and chock the tires. Before working under the vehicle, always place jack stands under the frame rails to ensure the vehicle can not drop. Failure to follow these steps could result in serious personal injury or death. 4 1 5 4 20–01 Pressure Relief Cap Check 02/05/2013 f500390 1. SAE Cap (for coolant overflow pressure relief only) 2. Surge Tank Filler Cap 3. Cold Maximum Coolant Level 4. Cold Minimum Coolant Level WARNING Fig.
1, Surge Tank Do not remove or loosen the surge tank cap until the engine and cooling system have completely cooled. Use extreme care when removing the cap. A sudden release of pressure from removing the cap prior to the system cooling can result in a surge of scalding coolant that could cause seri- ous personal injury. 20–02 Radiator Pressure- Flushing and Coolant Change NOTE: For additional instructions on cleaning and flushing the engine cooling system, see the applicable engine manufacturer’s maintenance and operation manual. 1. Remove the fill cap first, to relieve the cooling system pressure, then remove the SAE cap; see Fig. 1 . 1. Apply the vehicle parking brakes, then chock the tires.
Tilt the hood. 2. Using a radiator-cap tester, check the pressure cap to see if it maintains pressure to within 10% of the pressure rating marked on the cap. If it does not, replace the cap. Make sure that the replacement radiator cap is correctly rated for the cooling system of the vehicle. 2. Place a suitable container under the elbow of the radiator outlet pipe and the radiator. The con- tainer should hold at least 60 quarts (57 liters) of fluid. 3. There is a second valve in the radiator cap that opens under vacuum. This prevents the collapse of hoses and other parts that are not internally supported when the system cools. Inspect the vacuum-relief valve to be sure it is not stuck.
WARNING Do not remove or loosen the surge tank cap until the engine and cooling system have completely cooled. Use extreme care when removing the cap. A sudden release of pressure from removing the cap prior to the system cooling can result in a surge of scalding coolant that could cause seri- ous personal injury. 4. Make sure that the cap seals properly on the coolant filler neck seat, and that the radiator cap gasket is not damaged. On vehicles with screw-on caps with O-rings, make sure that the O-ring is not cracked or deteriorated. Replace the cap if the gasket shows deterioration or dam- age. 3. Remove the surge tank cap. 4. Remove the drain plug at the radiator end tank; see Fig. 2 .
Allow the coolant to drain. 122SD and Coronado 132 Maintenance Manual, February 2016 20/1