Freightliner — 122SD, Coronado 132

Engine Cooling/Radiator 20 5. If possible, drain the engine block of coolant. 20–03 Fan Clutch Check (Noise Emission Control) 6. Fill the cooling system with water. 7. Operate the engine until the water reaches oper- ating temperature. Borg Warner (Kysor) K26RA Fan Clutch 8. Drain the water and coolant mix from the cooling system. 9. Fill the cooling system with water again. 1. Disconnect the batteries at the negative termi- nals. Drain all air from the air system. 10. Drain the water from the cooling system. 11. Fill the cooling system with the appropriate cool- ant. Refer to the engine manufacturer’s service literature for specific coolant information. 2.

Measure the distance from the back surface of the fan clutch retaining plate to the forward-most edge of the fan belt pulley. See Fig. 3 , Ref. A. 2 3 1 4 5 3 6 A 05/27/93 f200237a With the fan clutch engaged, measure the distance at A ; measure it again with the fan clutch disengaged. 2 1. Bearing Housing 2. Retaining Plate 3. Fan Pulley 4. Air Inlet (from solenoid valve) 5. Air Cylinder 6. Fan 1 Fig. 3, Kysor K26RA Fan Clutch Lining Wear Check 3. Disconnect the line from the air inlet of the air cylinder. Connect a shop air hose to the inlet. 4. Apply a minimum of 100 psi (690 kPa) air pres- sure to the air cylinder—the bearing housing will move backwards, disengaging the clutch.

Again, measure the distance from the back surface of the retaining plate to the forward-most edge of the fan belt pulley. 09/14/2009 f200728 1. Transmission Coolant Hose 2. Drain Plug 3. Lower Radiator Hose 5. Compare the two measurements; if the difference between the two measurements exceeds 0.150 Fig. 2, Typical Coolant Drain Plug Location 122SD and Coronado 132 Maintenance Manual, February 2016 20/2