Engine Cooling/Radiator 20 inches (3.8 mm), the clutch lining is worn and must be replaced. See Group 20 of the vehicle Workshop Manual for clutch lining replacement instructions. 2 6. Release the air pressure, then disconnect the shop hose from the air inlet of the air cylinder. Connect the vehicle air hose to the inlet. 7. Connect the battery cables. Start the engine. Horton DriveMaster® Fan Clutch 1 NOTE: If any part of the fan clutch needs to be repaired or replaced after performing the checks below, see Group 20 of the vehicle Workshop Manual. f200724 07/24/2009 1. Disconnect the batteries at the negative termi- nals. 1. Air Filter Housing 2. Solenoid Valve 2.
Inspect the electrical connections and wires to the fan clutch solenoid; see Fig. 4 . Secure the connection if loose; replace wires and connectors if damaged. Fig. 4, Horton DriveMaster Air Solenoid Valve 3. Clean the fan clutch air solenoid valve filter, if equipped, as follows. 3.1 Unscrew the fan clutch solenoid valve air filter assembly and remove the filter ele- ment; see Fig. 5 . 1 3.2 Clean the filter element with cleaning sol- vent. 3.3 Using a clean, lint-free cloth, wipe off any excess solvent. 3.4 Reassemble the clutch valve solenoid air filter, then install it on the vehicle. 2 4. Check the fan for bent, cracked, or damaged blades. Replace if damaged.
Check for adequate clearance between the fan and other compo- nents. 3 07/24/2009 f200725 5. Check the fan belt for wear, tension, and align- ment. Correct if necessary. 1. Filter Element 2. Filter Bowl 3. Bleed Valve 6. Check for wear on the friction facing. Replace the friction facing if it is worn to a 3/16-inch (4.8- mm) thickness or less. Also check the facing for signs of oil contamination or burn marks. If evi- dence of oil or burn marks are found, replace the friction facing. Fig. 5, Horton DriveMaster Solenoid Valve Air Filter 7. Connect the battery cables. Start the engine, and charge the air system to 120 psi (827 kPa). Manually engage and disengage the fan clutch.
Check the fan and fan clutch from a distance. Look for vibration, fan blade contact, fan clutch slippage, and overall fan clutch operation. 122SD and Coronado 132 Maintenance Manual, February 2016 20/3