Freightliner — 122SD, Coronado 132

Engine Cooling/Radiator 20 If the fan clutch does not operate correctly, see Group 20 of the vehicle Workshop Manual for troubleshooting and repair procedures. 8. With the air system charged to 120 psi (827 kPa), check the fan clutch for audible air leaks, using a suitable listening device. Check at the solenoid valve, the air filter assem- bly, and the air hoses and fittings. See Fig. 6 . Using a wet finger or a soapy water solution, check for a leak in the same areas. f200581 05/30/2002 Fig. 6, Checking for Air Leaks (Horton DriveMaster) 9. If a leak is detected, remove the fan blade. In- stall a new seal kit. See Group 20 of the vehicle Workshop Manual for repair procedures. 10.

Check the fan drive for discoloration or any other signs of slipping or overheating. NOTE: The fan clutch may slip if the air supply pressure is below 70 psi (483 kPa) or if there is a leak inside the fan clutch. Any leak must be remedied. 11. Check the fan clutch bearings as follows. 11.1 Turn the fan in both directions and feel for worn hub bearings. 11.2 If possible, remove the drive belt and check for worn sheave bearings by turn- ing the sheave in both directions. 11.3 If either the hub or sheave bearings are worn, replace them, using a Horton Drive- Master Super Kit; see Group 20 of the vehicle Workshop Manual. 122SD and Coronado 132 Maintenance Manual, February 2016 20/4