Clutch 25 25–00 Safety Precautions 3. Wipe any dirt away from the grease fitting. See Fig. 2 . Using a pressure-type grease gun equipped with the recommended grease, lubri- cate the bearing until excess grease purges from the rear of the release bearing (toward the transmission). Safety Precautions in this section apply to all procedures within this group. DANGER When working on the vehicle, shut down the en- gine, set the parking brake, and chock the tires. Before working under the vehicle, always place jack stands under the frame rails to ensure the vehicle can not drop. Failure to follow these steps could result in serious personal injury or death.
25–01 Eaton Fuller Heavy-Duty Clutch Release Bearing Lubrication 1. Park the vehicle on a level surface. Apply the parking brakes, and chock the rear tires. NOTE: Some clutch release bearings are equipped with a lubrication extension, or lube tube, that extends outside of the clutch housing. 2. Remove the clutch inspection plate. See Fig. 1 . f250081a 05/27/93 Fig. 2, Release Bearing Grease Fitting NOTICE 1 Do not over-lubricate the clutch release bearing. Over-lubrication could contaminate the clutch in- ternally, causing clutch slippage and premature failure. Do not use chassis grease or multipurpose lubricants. 4.
Wipe off excess grease and apply to both the yoke finger and sleeve bushing contact points. See Fig. 3 . 5. Install the clutch inspection plate, if removed. 03/01/94 f250002a 1. Clutch Inspection Plate 25–02 Clutch Release Cross- Shaft Lubrication NOTE: For lubrication of the release bearing, Eaton Fuller recommends NLGI Grade 2 or 3 EP lithium grease with a 325°F (163°C) operat- ing temperature, or Roadranger Grease MP-2. Fig. 1, Clutch Inspection Plate The clutch release cross-shaft is equipped with two grease fittings on the transmission clutch housing. See Fig. 4 and Fig. 5 .
Wipe any dirt from the grease fittings, and lubricate with NLGI Grade 2 or 3 EP 122SD and Coronado 132 Maintenance Manual, February 2016 25/1