Clutch 25 1 2 08/10/2009 f250444 1. Sleeve Bushing Contact Point 2. Yoke Finger Contact Points Fig. 3, Grease the Contact Points f260146a 05/27/93 lithium grease with a 325°F (163°C) operating tem- perature, or Roadranger Grease MP-2. Fig. 5, Cross-Shaft Grease Fitting, Right-Side flows from the release bearing housing. Depress the clutch pedal a couple of times before starting the engine. If the clutch is equipped with a standard non-sealed clutch release bearing with a grease fitting , lubricate the bearing as follows: 1. Park the vehicle on a level surface. Apply the parking brakes, and chock the rear tires. 1 NOTE:
Some clutch release bearings are equipped with a lubrication extension that ex- tends outside of the clutch housing. It is not necessary to remove the clutch inspection plate when the lubrication extension is used. 2 2. Remove the clutch inspection plate, if necessary. See Fig. 1 . 10/19/93 1. Clutch Release Cross-Shaft 2. Grease Fitting f250048a NOTE: For lubrication of the release bearing, use Meritor Specification 0-661 Lithium Complex Grease, NLGI Grade 3. Fig. 4, Cross-Shaft Grease Fitting, Left-Side 3. Wipe any dirt from the grease fitting. See Fig. 2 .
Using a pressure-type grease gun equipped with recommended grease, lubricate the bearing until excess grease purges from the rear of the re- lease bearing (toward the transmission). 25–03 Meritor LitePedal Clutch Release Bearing Lubrication If the clutch is equipped with an optional sealed clutch release bearing , lubricate the bronze bushing located between the clutch bearing housing and the transmission input shaft. Use a pressure-type grease gun with Meritor Specification 0-661 Lithium Complex Grease, NLGI Grade 3, and lubricate until grease NOTICE Do not over-lubricate the clutch release bearing.
Over-lubrication could contaminate the clutch in- ternally, causing clutch slippage and premature failure. Do not use chassis grease or multipurpose lubricants. 122SD and Coronado 132 Maintenance Manual, February 2016 25/2