Frame and Frame Components 31 31–00 Safety Precautions 3. Check the fifth wheel plate for cracks. Check for sharp edges on top; the chamfer should be 1/8 to 1/4 inch (3 to 6 mm). Safety Precautions in this section apply to all procedures within this group. 4. When the wheel is locked, the safety latch must swing free and fall freely into position. See Fig. 1 . DANGER When working on the vehicle, shut down the en- gine, set the parking brake, and chock the tires. Before working under the vehicle, always place jack stands under the frame rails to ensure the vehicle can not drop. Failure to follow these steps could result in serious personal injury or death.
1 2 31–01 Fifth Wheel Inspection 3 WARNING 4 All fifth wheel maintenance, adjustment, and re- building must be done only by a qualified me- chanic. Improper or incomplete procedures could result in a possible disengagement of the trailer from the tractor, which could result in personal injury or property damage. f311052 10/29/2007 1. Lubricant Grooves 2. Safety Latch 3. Release Handle 4. Mount Fig. 1, Holland FWS1 Fifth Wheel Parts are under spring compression. Wear safety goggles while servicing the fifth wheel. Failure to do so can result in personal injury, due to parts ejecting with force. 5. The lever bar and release handle must be in proper alignment. See Fig. 2 .
Compare the lever bar and release handle alignment to a new, or a properly operating lever bar and release handle. Replace any bent or misaligned lever bar or re- lease handle. WARNING All fifth wheel maintenance, adjustment, and re- building must be done only by a qualified me- chanic. Improper or incomplete procedures could result in a possible disengagement of the trailer from the tractor, which could result in personal injury or property damage. 1 Parts are under spring compression. Wear safety goggles while servicing the fifth wheel. Failure to do so can result in personal injury, due to parts ejecting with force. Holland FWS1 2 1. Disconnect the tractor from the trailer.
For in- structions, see the vehicle Driver’s/Operator’s Manual. 03/28/2013 f311140 1. Release Handle 2. Lever Bar Fig. 2, Lever Bar and Release Handle Alignment 2. Thoroughly steam clean the fifth wheel. 122SD and Coronado 132 Maintenance Manual, February 2016 31/1