Freightliner — 122SD, Coronado 132

Frame and Frame Components 31 6. Check all cotter pins for cracking or damage. Re- place any cotter pin that shows any signs of damage. 7. Check all mounting bolts for signs of fatigue, and tighten them to the proper torque. For torque specifications, see Group 00 of the vehicle Workshop Manual. Inspect all angles, plates, and brackets for cracks or other damage. A 8. Replace cracked, worn, or damaged parts with new parts. Replace all loose mounting bolts with 5/8–11 SAE grade 8 bolts, grade C locknuts, and hardened washers. Do not re-use bolts, nuts, and washers on fifth wheel mountings. 9. After inspecting the fifth wheel, lubricate all mov- ing parts with a chassis or multipurpose grease.

See MOP 31–02 for lubrication instructions. Holland FW35 04/11/2011 f310887 B A. The nut and washer should be snug against the fifth wheel. B. The locks should be completely closed around the kingpin. 1. Disconnect the tractor from the trailer. For in- structions, see the vehicle Driver’s/Operator’s Manual. Fig. 3, Holland Fifth Wheel Properly Closed 2. Thoroughly steam clean all fifth wheel compo- nents before inspection. 2. Thoroughly steam clean the fifth wheel. 3. Check for cracks in the fifth wheel assembly, mounting brackets, and mounting parts. 3. Check for cracks in the fifth wheel assembly, mounting brackets, and mounting parts. 4.

Ensure that both bracket pins are in place and secured by retainer pins and cotter pins. See Fig. 4 . 4. Check the fastener torques on the fifth wheel assembly and fifth wheel mounting. Tighten bolts and nuts as needed. Replace missing or dam- aged bolts. 5. For fifth wheels equipped with bracket liners, rock the fifth wheel. If it does not rock freely, re- move the top plate and inspect the bracket lin- ers. Replace liners that are broken or less than 0.125 inch (3 mm) thick at the top of the liners. For the liner replacement procedure, see the Fontaine website, www.fifthwheel.com . 5.

Inspect the fifth wheel for bent, worn, damaged, and missing parts; replace them as needed with genuine Holland parts. 6. Using a Holland Kingpin Lock Tester (Holland tool number TF-TLN-5001, available through the PDCs as HLD TFTLN5001), check the operation of the locking mechanism by opening and closing the locks. See Fig. 3 . 6. Check the jaw and stationary jaw for mushroom- ing, and check that the serrations at the jaw and wedge are in good condition. 7. After inspecting the fifth wheel, lubricate all mov- ing parts with a chassis or multipurpose grease. See MOP 31–02 in this manual for lubrication instructions. Fontaine 7. Test the secondary safety lock latch for ease of operation. 8.

Check for loose nuts or bolts on the fifth wheel and the mounting. Set a torque wrench to the maximum torque value for the bolt being checked, and confirm that the torque is to speci- fication. Do not loosen the bolt to check the torque. For torque specifications, see Group 00 of the vehicle Workshop Manual. 1. Disconnect the tractor from the trailer. For in- structions, see the vehicle Driver’s/Operator’s Manual. 122SD and Coronado 132 Maintenance Manual, February 2016 31/2