Frame and Frame Components 31 9. Check all springs to see if they are securely fas- tened, and are not deformed. WARNING Do not disassemble the fifth wheel to inspect the springs. The springs are under extreme pressure, and could cause serious injury. 10. Check the wedge adjustment. 10.1 Close the fifth wheel on a standard 2-inch (50-mm) kingpin or similar 2-inch (50-mm) diameter shaft so that it locks. 10.2 Push on the wedge stop rod with hand pressure. It should move in 1/4 inch (6 mm) and spring back out on release. 09/01/2009 f311101 Fig.
5, Bracket Pin Bolt Locking Tabs If the free travel is not 1/4 inch (6 mm), adjust the distance to 1/4 inch (6 mm) by turning the wedge stop rod, on the right side of the top plate, clockwise to reduce the gap and counter-clockwise to in- crease it. 6. If the fifth wheel is equipped with low-lube plates, check the plates and replace if damaged or worn down to the securing bolts. It is normal for out- side edges of the plate to pucker slightly; this does not affect performance. 7. Check the fifth wheel adjustment. Using a lock tester, lock and unlock the fifth wheel several times. Make sure that the locking mechanism works properly. 11. Replace cracked, worn, or damaged parts with new parts.
Replace all loose mounting bolts with 5/8–11 SAE grade 8 bolts, grade C locknuts, and hardened washers. Do not re-use bolts, nuts, and washers on fifth wheel mountings. The lock is properly adjusted if: the wheel locks and unlocks easily each time and the lock tester rotates freely. 12. After inspecting the fifth wheel, lubricate all mov- ing parts with a chassis or multipurpose grease. Apply a generous coating of grease to the top plate to fill the grooves, or depressions, on the top plate. See MOP 31–02 in this manual for lu- brication instructions. Jost The lock is too loose if: you feel fore-aft play when pulling and pushing on the lock tester handle. See Fig. 6 , Ref. A.
The lock is too tight if: the lock tester does not rotate freely in the lock. See Fig. 6 , Ref. B. 8. If the lock is improperly adjusted, correct as fol- lows. 1. Disconnect the tractor from the trailer. For in- structions, see the vehicle Driver’s/Operator’s Manual. If the lock is too tight, loosen the jam nut, turn the adjustment bolt clockwise one full turn, then reset the jam nut. Lock and unlock the mecha- nism several times to test. Repeat if necessary. See Fig. 7 . 2. Thoroughly steam clean the fifth wheel. 3. Check the mounting for missing or damaged fas- teners, and broken components. Replace or re- pair as needed.
If the lock is too loose, loosen the jam nut, turn the adjustment bolt counterclockwise one full turn, then reset the jam nut. Lock and unlock the mechanism several times to test. Repeat if nec- essary. See Fig. 7 . 4. Inspect the bracket pin bolts. Make sure the lock- ing tabs are properly securing the bolts in place. See Fig. 5 . 5. Check the fifth wheel for bent, worn, or broken parts. Replace as needed. 9. If the fifth wheel is equipped with a sliding mechanism, inspect and adjust it as follows. 122SD and Coronado 132 Maintenance Manual, February 2016 31/4