Suspension 32 32–00 Safety Precautions a side to side crack extending beyond 3/4 of the length of the spring; Safety Precautions in this section apply to all procedures within this group. a top to bottom crack extending beyond 3/4 of the length of the spring; DANGER intersecting cracks of any length. When working on the vehicle, shut down the en- gine, set the parking brake, and chock the tires. Before working under the vehicle, always place jack stands under the frame rails to ensure the vehicle can not drop. Failure to follow these steps could result in serious personal injury or death.
The Liteflex composite spring should also be re- moved from service if splintering has occured to the point where noticeable vehicle ride height loss has occurred. 32–01 Suspension Inspection A Front Suspension Check WARNING Do not replace individual leaves of a damaged leaf spring assembly; replace the complete spring as- sembly. Visible damage (cracks or breaks) to one leaf causes hidden damage to other leaves. Re- placement of only the visibly damaged part(s) is no assurance that the spring is safe. On front spring assemblies, if cracks or breaks exist in the two top leaves, a loss of vehicle control could occur.
Failure to replace a damaged spring assem- bly could cause an accident resulting in property damage, serious personal injury, or death. B C 08/14/2008 f321135 A. Side to side crack extending beyond 3/4 of the length of the spring B. Top to bottom crack extending beyond 3/4 of the length of the spring C. Intersecting cracks of any length Inspect the front spring assemblies for cracked, bro- ken, or abnormally bent leaves. If any of these condi- tions exist, replace the spring assembly. See Group 32 of the 122SD and Coronado Workshop Manual for instructions. Composite Springs Fig.
1, Out-of-Service Conditions, Composite Spring Shock Absorber Check, Front and Rear Suspensions The Commercial Vehicle Safety Alliance (CVSA) de- fines a crack that causes out-of-service conditions for composite spring assemblies, as a separation in any axis, which passes completely through the composite spring material. Make sure the shock absorber brackets are tight, and the shock absorber is not striking or rubbing the frame or some other part of the chassis. Striking or rubbing the frame is characterized by chafe marks on the shock absorber body and the frame rail. See Fig. 2 . Check the rubber mounting bushings for cracks, cuts, swelling, and dry rot.
Also, check the bushings for missing pieces. Replace the bushings as needed. For additional information on composite spring as- semblies, refer to the CVSA, Out of Service (OOS) Criteria . Inspect the Liteflex spring for cracks that result in an out-of-service condition as follows (see Fig. 1 ): 122SD and Coronado 132 Maintenance Manual, February 2016 32/1