Suspension 32 IMPORTANT: To prevent voiding the warranty on Barksdale height-control valves, note the fol- lowing: 1 2 Do not overtighten the bolts in the Barksdale height-control valve housing. The bolts should not be loose, and should not require tightening. Only if necessary, tighten the valve housing bolts 45 lbf·in (500 N·cm). Any damage to the valve housing will void the warranty. 3 Do not attempt to disassemble the Barksdale valve body or the control lever. There are no serviceable parts in the valve, and any disas- sembly will void the warranty.
4 NOTICE When removing or loosening a Barksdale height- control valve from a mounting bracket, always hold the valve-side mounting studs in place with an Allen wrench while loosening or tightening the nuts that attach the valve to the bracket. Because the mounting studs are threaded into the valve body, loosening the nuts without holding the studs can tighten the studs, which can crush the valve body and damage the valve. Conversely, tightening the nuts without holding the studs can back the studs out, causing a separation of the two halves of the valve body, and possibly a leak. 5 01/12/2000 f320562a 1. Valve Mounting Bracket 2. Height-Control Valve 3. Stud Bolt 4. Linkage Rod 5. Axle 1.
Park the vehicle on a level surface, using a light application of the brakes. Do not apply the park- ing brakes. Shift the transmission into neutral, and build the secondary air pressure to at least 100 psi (690 kPa). Shut down the engine. Fig. 6, Typical Barksdale Height-Control Valve Installation (side view) 5. If the axle stop measurement is not correct, see Group 32 of the 122SD and Coronado Work- shop Manual for adjustment procedures. 2. Mark the location of the front and rear tires on the floor, and chock the tires on one axle only. 6. Apply the parking brakes, and remove the chocks. Chalmers Suspension 3.
Check that the height-control valve vertical link- age is connected and oriented correctly. NOTE: The stud bolt that fastens the height- control valve horizontal lever to the vertical link- age is oriented correctly when the linkage rod is vertical, as viewed from the side of the vehicle; see Fig. 6 . The rod may be on the forward or aft side of the lever to get it to be vertical. 1. Chock the front tires, place the transmission in neutral, and release the parking brakes. 2. Power wash the suspension, or clean it with a hard-bristle brush before performing a visual in- spection. 3. Inspect the rubber bushings for cracks or other damage. 4.
Measure the distance from the axle stop to the top of the axle U-bolt pad. The correct distance is determined by the axle and suspension con- figurations; refer to Group 32 of the 122SD and Coronado Workshop Manual for details. Try to move the torque rod ends using your hands only, and check for any free-play. If free- play is felt, replace the torque rod end bushing. Do not use a pry bar to check for free-play. Use 122SD and Coronado 132 Maintenance Manual, February 2016 32/4