Suspension 32 of a pry bar may lead to premature bushing re- placement. 4. Lift the rear of the vehicle and support the frame on jack stands to unload the suspension compo- nents. The vehicle is lifted high enough when the beam ends are off of the saddles. 1 Inspect the walking beam for cracks or other damage. If damage is found, replace the walking beam. Keep the vehicle supported by the jack stands for the next operation. A 5. Manipulate the walking beam so that a microm- eter, vernier, or dial caliper can be used to deter- mine the wear area thickness on the bottom face. See Fig. 7.
Measurements should be taken a minimum of 1/2 inch from the beam flange edges to eliminate any edge wear that may have occurred. Subtract the wear area thickness (see Fig. 7 , Ref. B) from the thickness at the non- wear area (see Fig. 7 , Ref. A) to determine the amount of wear. B 09/27/95 f320432 A. Non-Wear Area B. Wear Area 1. Walking Beam If the beams show any wear greater than 0.062 inch (1.5 mm), a Chalmers wear plate must be installed, or the walking beam must be replaced. Fig. 7, Walking Beam End Wear Thickness 6. Rotate the restrictor cans 360 degrees and in- spect the cans for cracks, severe corrosion, and distortion.
If any of these conditions are present, or the restrictor can is missing, replace the re- strictor can. with maintenance-free rubber bushings, and do not require lubrication. Rear Suspension Chalmers WARNING No lubrication is required on the Chalmers rear suspension. Freightliner Spring Single Axle Replace all cracked or missing restrictor cans. Failure to do so could lead to loss of vehicle con- trol, which could result in property damage, seri- ous personal injury, or death. 32–02 Suspension Lubrication No lubrication is required on Freightliner single axle rear suspensions.
Tandem Axle Front Suspension Lubricate the equalizer cap-and-tube assembly bush- ings by applying multipurpose chassis grease at the grease fitting until old grease is forced out from the cap-and-tube assembly; see Fig. 8 . Hendrickson Wipe all dirt away from the grease fittings (if equipped) on the spring-eye bushings. Apply multi- purpose chassis grease with a pressurized grease gun until old grease is forced out. NOTE: Service Schedule IV vehicles equipped with a 12,000 lb (5452 kg) front axle are fitted The Hendrickson RS Series suspension does not require lubrication. 122SD and Coronado 132 Maintenance Manual, February 2016 32/5